Skip to contentSkip to conversation

Staging:fbtft: Replace decimal permissions with 4 digit octal

PATCH New Nadim Almas 1 participant 1 message Oct 24, 2016

Subsystems (2)
Staging Fbtft Framebuffer drivers
lore
Share & tools
lore

Nadim Almas

author
#0 lore raw

PATCH 1/1 Staging:fbtft: Replace decimal permissions with 4 digit octal

ERROR: Use 4 digit octal (0777) not decimal permissions

This error was detected by checkpatch.pl

Signed-off-by Nadim Almas <[email protected]>
---
 drivers/staging/fbtft/fb_ili9325.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)
drivers/staging/fbtft/fb_ili9325.c +5 -5
index 4ab4479..19e33ba 100644
@@ -33,23 +33,23 @@
 			"04 16 2 7 6 3 2 1 7 7"
 
 static unsigned int bt = 6; /* VGL=Vci*4 , VGH=Vci*4 */
-module_param(bt, uint, 0);
+module_param(bt, uint, 0000);
 MODULE_PARM_DESC(bt, "Sets the factor used in the step-up circuits");
 
 static unsigned int vc = 0x03; /* Vci1=Vci*0.80 */
-module_param(vc, uint, 0);
+module_param(vc, uint, 0000);
 MODULE_PARM_DESC(vc, "Sets the ratio factor of Vci to generate the reference voltages Vci1");
 
 static unsigned int vrh = 0x0d; /* VREG1OUT=Vci*1.85 */
-module_param(vrh, uint, 0);
+module_param(vrh, uint, 0000);
 MODULE_PARM_DESC(vrh, "Set the amplifying rate (1.6 ~ 1.9) of Vci applied to output the VREG1OUT");
 
 static unsigned int vdv = 0x12; /* VCOMH amplitude=VREG1OUT*0.98 */
-module_param(vdv, uint, 0);
+module_param(vdv, uint, 0000);
 MODULE_PARM_DESC(vdv, "Select the factor of VREG1OUT to set the amplitude of Vcom");
 
 static unsigned int vcm = 0x0a; /* VCOMH=VREG1OUT*0.735 */
-module_param(vcm, uint, 0);
+module_param(vcm, uint, 0000);
 MODULE_PARM_DESC(vcm, "Set the internal VcomH voltage");
 
 /*
Signature · 1 line
2.7.4