arm64: tegra: Add VDD_GPU regulator to Jetson TX1
Subsystems (2)
PATCH 1/1 arm64: tegra: Add VDD_GPU regulator to Jetson TX1
From: Alexandre Courbot <[email protected]>
Add the VDD_GPU regulator (a GPIO-enabled PWM regulator) to the Jetson TX1 board. This addition allows the GPU to be used provided the bootloader properly enabled the GPU node.
Signed-off-by Alexandre Courbot <[email protected]>
Signed-off-by Thierry Reding <[email protected]>
---
Hi ARM-SoC maintainers,
This was part of a pull request for v4.8 but it seems everything of the pull request except this one patch made it upstream. I think perhaps it may have been the dependency on the regulator tree that made you defer this to after v4.8-rc1 and then I forgot to resend.
Here's a link to the pull request:
http://lists.infradead.org/pipermail/linux-arm-kernel/2016-July/443469.html
There was no discussion on the list, but we might have discussed it on IRC.
Can you please pick this up for v4.10-rc1?
Thanks,
Thierry
arch/arm64/boot/dts/nvidia/tegra210-p2180.dtsi | 18 ++++++++++++++++++ 1 file changed, 18 insertions(+)
arch/arm64/boot/dts/nvidia/tegra210-p2180.dtsi +18 -0
@@ -21,6 +21,10 @@ reg = <0x0 0x80000000 0x1 0x0>; }; + gpu at 57000000 { + vdd-supply = <&vdd_gpu>; + }; + /* debug port */ serial at 70006000 { status = "okay";
@@ -291,4 +295,18 @@ clock-frequency = <32768>; }; }; + + regulators { + vdd_gpu: regulator at 100 { + compatible = "pwm-regulator"; + reg = <100>; + pwms = <&pwm 1 4880>; + regulator-name = "VDD_GPU"; + regulator-min-microvolt = <710000>; + regulator-max-microvolt = <1320000>; + enable-gpios = <&pmic 6 GPIO_ACTIVE_HIGH>; + regulator-ramp-delay = <80>; + regulator-enable-ramp-delay = <1000>; + }; + }; };
Signature · 1 line
2.10.2