mmc: tegra: Support module reset
Subsystems (3)
PATCH v3 1/2 mmc: tegra: Support module reset
From: Thierry Reding <[email protected]>
The device tree binding for the SDHCI controller found on Tegra SoCs specifies that a reset control can be provided by the device tree. No code was ever added to support the module reset, which can cause the driver to try and access registers from a module that's in reset. On most Tegra SoC generations doing so would cause a hang.
Note that it's unlikely to see this happen because on most platforms these resets will have been deasserted by the bootloader. However the portability can be improved by making sure the driver deasserts the reset before accessing any registers.
Since resets are synchronous on Tegra SoCs, the platform driver needs to implement a custom ->remove() callback now to make sure the clock is disabled after the reset is asserted.
---
Changes in v3:
- use consistent variable names
Changes in v2:
- assert reset in ->probe() error path
- remove unneeded PCI specific quirk
drivers/mmc/host/sdhci-tegra.c | 43 +++++++++++++++++++++++++++++++++++++++++- 1 file changed, 42 insertions(+), 1 deletion(-)
drivers/mmc/host/sdhci-tegra.c +42 -1
@@ -21,6 +21,7 @@#include <linux/io.h> #include <linux/of.h> #include <linux/of_device.h> +#include <linux/reset.h> #include <linux/mmc/card.h> #include <linux/mmc/host.h> #include <linux/mmc/mmc.h>
@@ -65,6 +66,8 @@ struct sdhci_tegra {struct gpio_desc *power_gpio;bool ddr_signaling;bool pad_calib_required; + +struct reset_control *rst; };static u16 tegra_sdhci_readw (struct sdhci_host *host,int reg)
@@ -489,6 +492,25 @@ static int sdhci_tegra_probe(struct platform_device *pdev)clk_prepare_enable (clk); pltfm_host->clk = clk; + tegra_host->rst =devm_reset_control_get (&pdev->dev,"sdhci" ); +if (IS_ERR (tegra_host->rst)) { + rc =PTR_ERR (tegra_host->rst); +dev_err (&pdev->dev,"failed to get reset control: %d\n" , rc); + goto err_rst_get; + } + + rc =reset_control_assert (tegra_host->rst); +if (rc) + goto err_rst_get; + +usleep_range (2000 ,4000 ); + + rc =reset_control_deassert (tegra_host->rst); +if (rc) + goto err_rst_get; + +usleep_range (2000 ,4000 ); + rc =sdhci_add_host (host);if (rc) goto err_add_host;
@@ -496,6 +518,8 @@ static int sdhci_tegra_probe(struct platform_device *pdev)return 0 ; err_add_host: +reset_control_assert (tegra_host->rst); +err_rst_get:clk_disable_unprepare (pltfm_host->clk); err_clk_get: err_power_req:
@@ -504,6 +528,23 @@ static int sdhci_tegra_probe(struct platform_device *pdev)return rc; } +static int sdhci_tegra_remove (struct platform_device *pdev) +{ +struct sdhci_host *host =platform_get_drvdata (pdev); +struct sdhci_pltfm_host *pltfm_host =sdhci_priv (host); +struct sdhci_tegra *tegra_host =sdhci_pltfm_priv (pltfm_host); + +sdhci_remove_host (host,0 ); + +reset_control_assert (tegra_host->rst); +usleep_range (2000 ,4000 ); +clk_disable_unprepare (pltfm_host->clk); + +sdhci_pltfm_free (pdev); + +return 0 ; +} +static struct platform_driver sdhci_tegra_driver = { .driver = { .name ="sdhci-tegra" ,
@@ -511,7 +552,7 @@ static struct platform_driver sdhci_tegra_driver = { .pm = &sdhci_pltfm_pmops, }, .probe = sdhci_tegra_probe, - .remove = sdhci_pltfm_unregister, + .remove = sdhci_tegra_remove, };module_platform_driver (sdhci_tegra_driver);
Signature · 1 line
2.12.0
A message that is not in the archive (sent off-list or not yet received): 20170308190040.28386-1-thierry.reding-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org
PATCH v3 2/2 mmc: tegra: Add Tegra186 support
From: Thierry Reding <[email protected]>
The SDHCI controller found on NVIDIA Tegra186 SoCs is very similar to the one on prior generations of Tegra and can be supported by the same driver.
--- drivers/mmc/host/sdhci-tegra.c | 16 ++++++++++++++++ 1 file changed, 16 insertions(+)
drivers/mmc/host/sdhci-tegra.c +16 -0
@@ -434,7 +434,23 @@ static const struct sdhci_tegra_soc_data soc_data_tegra210 = { .pdata = &sdhci_tegra210_pdata, }; +static const struct sdhci_pltfm_data sdhci_tegra186_pdata = { + .quirks =SDHCI_QUIRK_BROKEN_TIMEOUT_VAL | +SDHCI_QUIRK_DATA_TIMEOUT_USES_SDCLK | +SDHCI_QUIRK_SINGLE_POWER_WRITE | +SDHCI_QUIRK_NO_HISPD_BIT | +SDHCI_QUIRK_BROKEN_ADMA_ZEROLEN_DESC | +SDHCI_QUIRK_CAP_CLOCK_BASE_BROKEN , + .quirks2 =SDHCI_QUIRK2_PRESET_VALUE_BROKEN , + .ops = &tegra114_sdhci_ops, +}; + +static const struct sdhci_tegra_soc_data soc_data_tegra186 = { + .pdata = &sdhci_tegra186_pdata, +}; +static const struct of_device_id sdhci_tegra_dt_match[] = { + { .compatible ="nvidia,tegra186-sdhci" , .data = &soc_data_tegra186 }, { .compatible ="nvidia,tegra210-sdhci" , .data = &soc_data_tegra210 }, { .compatible ="nvidia,tegra124-sdhci" , .data = &soc_data_tegra124 }, { .compatible ="nvidia,tegra114-sdhci" , .data = &soc_data_tegra114 },
Signature · 1 line
2.12.0
Ulf Hansson
AppliedRe: [PATCH v3 2/2] mmc: tegra: Add Tegra186 support
Quoted 8 lines · Thierry Reding
From: Thierry Reding <[email protected]>
The SDHCI controller found on NVIDIA Tegra186 SoCs is very similar to the one on prior generations of Tegra and can be supported by the same driver.
Acked-by Adrian Hunter <[email protected]>Signed-off-by Thierry Reding <[email protected]>
Thanks, applied for next!
However, the new compatible string must be documented. Please send a patch on top to fix that!
Kind regards
Uffe
Quoted 35 lines
--- drivers/mmc/host/sdhci-tegra.c | 16 ++++++++++++++++ 1 file changed, 16 insertions(+)drivers/mmc/host/sdhci-tegra.c +16
-1@@ -434,7 +434,23 @@ static const struct sdhci_tegra_soc_data soc_data_tegra210 = { .pdata = &sdhci_tegra210_pdata, }; +static const struct sdhci_pltfm_data sdhci_tegra186_pdata = { + .quirks =SDHCI_QUIRK_BROKEN_TIMEOUT_VAL | +SDHCI_QUIRK_DATA_TIMEOUT_USES_SDCLK | +SDHCI_QUIRK_SINGLE_POWER_WRITE | +SDHCI_QUIRK_NO_HISPD_BIT | +SDHCI_QUIRK_BROKEN_ADMA_ZEROLEN_DESC | +SDHCI_QUIRK_CAP_CLOCK_BASE_BROKEN , + .quirks2 =SDHCI_QUIRK2_PRESET_VALUE_BROKEN , + .ops = &tegra114_sdhci_ops, +}; + +static const struct sdhci_tegra_soc_data soc_data_tegra186 = { + .pdata = &sdhci_tegra186_pdata, +}; +static const struct of_device_id sdhci_tegra_dt_match[] = { + { .compatible ="nvidia,tegra186-sdhci" , .data = &soc_data_tegra186 }, { .compatible ="nvidia,tegra210-sdhci" , .data = &soc_data_tegra210 }, { .compatible ="nvidia,tegra124-sdhci" , .data = &soc_data_tegra124 }, { .compatible ="nvidia,tegra114-sdhci" , .data = &soc_data_tegra114 }, --2.12.0
Ulf Hansson
AppliedQuoted 13 lines · Thierry Reding
From: Thierry Reding <[email protected]>
The device tree binding for the SDHCI controller found on Tegra SoCs specifies that a reset control can be provided by the device tree. No code was ever added to support the module reset, which can cause the driver to try and access registers from a module that's in reset. On most Tegra SoC generations doing so would cause a hang.
Note that it's unlikely to see this happen because on most platforms these resets will have been deasserted by the bootloader. However the portability can be improved by making sure the driver deasserts the reset before accessing any registers.
Quoted 6 lines
Since resets are synchronous on Tegra SoCs, the platform driver needs to implement a custom ->remove() callback now to make sure the clock is disabled after the reset is asserted.
Acked-by Adrian Hunter <[email protected]>Signed-off-by Thierry Reding <[email protected]>
Thanks, applied for next!
Kind regards
Uffe
Quoted 103 lines
---
Changes in v3:
- use consistent variable namesChanges in v2:
- assert reset in ->probe() error path
- remove unneeded PCI specific quirkdrivers/mmc/host/sdhci-tegra.c | 43 +++++++++++++++++++++++++++++++++++++++++- 1 file changed, 42 insertions(+), 1 deletion(-)drivers/mmc/host/sdhci-tegra.c +42
-2@@ -21,6 +21,7 @@#include <linux/io.h> #include <linux/of.h> #include <linux/of_device.h> +#include <linux/reset.h> #include <linux/mmc/card.h> #include <linux/mmc/host.h> #include <linux/mmc/mmc.h> @@ -65,6 +66,8 @@ struct sdhci_tegra {struct gpio_desc *power_gpio;bool ddr_signaling;bool pad_calib_required; + +struct reset_control *rst; };static u16 tegra_sdhci_readw (struct sdhci_host *host,int reg)@@ -489,6 +492,25 @@ static int sdhci_tegra_probe(struct platform_device *pdev)clk_prepare_enable (clk); pltfm_host->clk = clk; + tegra_host->rst =devm_reset_control_get (&pdev->dev,"sdhci" ); +if (IS_ERR (tegra_host->rst)) { + rc =PTR_ERR (tegra_host->rst); +dev_err (&pdev->dev,"failed to get reset control: %d\n" , rc); + goto err_rst_get; + } + + rc =reset_control_assert (tegra_host->rst); +if (rc) + goto err_rst_get; + +usleep_range (2000 ,4000 ); + + rc =reset_control_deassert (tegra_host->rst); +if (rc) + goto err_rst_get; + +usleep_range (2000 ,4000 ); + rc =sdhci_add_host (host);if (rc) goto err_add_host;@@ -496,6 +518,8 @@ static int sdhci_tegra_probe(struct platform_device *pdev)return 0 ; err_add_host: +reset_control_assert (tegra_host->rst); +err_rst_get:clk_disable_unprepare (pltfm_host->clk); err_clk_get: err_power_req:@@ -504,6 +528,23 @@ static int sdhci_tegra_probe(struct platform_device *pdev)return rc; } +static int sdhci_tegra_remove (struct platform_device *pdev) +{ +struct sdhci_host *host =platform_get_drvdata (pdev); +struct sdhci_pltfm_host *pltfm_host =sdhci_priv (host); +struct sdhci_tegra *tegra_host =sdhci_pltfm_priv (pltfm_host); + +sdhci_remove_host (host,0 ); + +reset_control_assert (tegra_host->rst); +usleep_range (2000 ,4000 ); +clk_disable_unprepare (pltfm_host->clk); + +sdhci_pltfm_free (pdev); + +return 0 ; +} +static struct platform_driver sdhci_tegra_driver = { .driver = { .name ="sdhci-tegra" ,@@ -511,7 +552,7 @@ static struct platform_driver sdhci_tegra_driver = { .pm = &sdhci_pltfm_pmops, }, .probe = sdhci_tegra_probe, - .remove = sdhci_pltfm_unregister, + .remove = sdhci_tegra_remove, };module_platform_driver (sdhci_tegra_driver); --2.12.0