staging: iio: cdc: replace mlock with driver private lock

The IIO subsystem is redefining iio_dev mlock to be used by IIO core only for protecting device operating mode changes.

In driver ad7746 wherever mlock was used to protect hardware state changes, it has been replaced with a driver private lock.

Signed-off-by Aishwarya Pant <[email protected]>

---
 drivers/staging/iio/cdc/ad7746.c | 18 ++++++++++--------
 1 file changed, 10 insertions(+), 8 deletions(-)

drivers/staging/iio/cdc/ad7746.c +10 -8

index 81f8b9e..6e3f99c 100644
@@ -91,6 +91,7 @@
 
 struct ad7746_chip_info {
 	struct i2c_client *client;
+	struct mutex lock; /* protect sensor state */
 	/*
 	 * Capacitive channel digital filter setup;
 	 * conversion time/update rate setup per channel

@@ -298,11 +299,11 @@ static inline ssize_t ad7746_start_calib(struct device *dev,
 	if (!doit)
 		return 0;
 
-	mutex_lock(&indio_dev->mlock);
+	mutex_lock(&chip->lock);
 	regval |= chip->config;
 	ret = i2c_smbus_write_byte_data(chip->client, AD7746_REG_CFG, regval);
 	if (ret < 0) {
-		mutex_unlock(&indio_dev->mlock);
+		mutex_unlock(&chip->lock);
 		return ret;
 	}
 

@@ -310,12 +311,12 @@ static inline ssize_t ad7746_start_calib(struct device *dev,
 		msleep(20);
 		ret = i2c_smbus_read_byte_data(chip->client, AD7746_REG_CFG);
 		if (ret < 0) {
-			mutex_unlock(&indio_dev->mlock);
+			mutex_unlock(&chip->lock);
 			return ret;
 		}
 	} while ((ret == regval) && timeout--);
 
-	mutex_unlock(&indio_dev->mlock);
+	mutex_unlock(&chip->lock);
 
 	return len;
 }

@@ -426,7 +427,7 @@ static int ad7746_write_raw(struct iio_dev *indio_dev,
 	struct ad7746_chip_info *chip = iio_priv(indio_dev);
 	int ret, reg;
 
-	mutex_lock(&indio_dev->mlock);
+	mutex_lock(&chip->lock);
 
 	switch (mask) {
 	case IIO_CHAN_INFO_CALIBSCALE:

@@ -521,7 +522,7 @@ static int ad7746_write_raw(struct iio_dev *indio_dev,
 	}
 
 out:
-	mutex_unlock(&indio_dev->mlock);
+	mutex_unlock(&chip->lock);
 	return ret;
 }
 

@@ -534,7 +535,7 @@ static int ad7746_read_raw(struct iio_dev *indio_dev,
 	int ret, delay, idx;
 	u8 regval, reg;
 
-	mutex_lock(&indio_dev->mlock);
+	mutex_lock(&chip->lock);
 
 	switch (mask) {
 	case IIO_CHAN_INFO_RAW:

@@ -658,7 +659,7 @@ static int ad7746_read_raw(struct iio_dev *indio_dev,
 		ret = -EINVAL;
 	}
 out:
-	mutex_unlock(&indio_dev->mlock);
+	mutex_unlock(&chip->lock);
 	return ret;
 }
 

@@ -686,6 +687,7 @@ static int ad7746_probe(struct i2c_client *client,
 	if (!indio_dev)
 		return -ENOMEM;
 	chip = iio_priv(indio_dev);
+	mutex_init(&chip->lock);
 	/* this is only used for device removal purposes */
 	i2c_set_clientdata(client, indio_dev);