parisc: Report SIGSEGV instead of SIGBUS when running out of stack
Helge Deller
maintainerPATCH 1/1 parisc: Report SIGSEGV instead of SIGBUS when running out of stack
When a process runs out of stack the parisc kernel wrongly faults with SIGBUS instead of the expected SIGSEGV signal.
This example shows how the kernel faults:do_page_fault() command='a.out' type=15 address=0xfaac2000 in libc-2.24.so[f8308000+16c000] trap #15: Data TLB miss fault, vm_start = 0xfa2c2000, vm_end = 0xfaac2000
The vma->vm_end value is the first address which does not belong to the vma, so adjust the check to include vma->vm_end to the range for which to send the SIGSEGV signal.
This patch unbreaks building the debian libsegv package.
Signed-off-by Helge Deller <[email protected]>
arch/parisc/mm/fault.c +1 -1
@@ -367,7 +367,7 @@ void do_page_fault(struct pt_regs *regs, unsigned long code,case 15 :/* Data TLB miss fault/Data page fault */ /* send SIGSEGV when outside of vma */ if (!vma || - address < vma->vm_start || address > vma->vm_end) { + address < vma->vm_start || address >= vma->vm_end) { si.si_signo =SIGSEGV ; si.si_code =SEGV_MAPERR ;break ;