ARM: dts: imx6: RDU2: disable over-current detection on USB H1
Subsystems (2)
PATCH 1/2 ARM: dts: imx6: RDU2: disable over-current detection on USB H1
Just like the OTG port, USB H1 has no over-current detection wired up.
--- arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi | 1 + 1 file changed, 1 insertion(+)
arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi +1 -0
@@ -805,6 +805,7 @@ &usbh1 { vbus-supply = <®_5p0v_main>; + disable-over-current; status = "okay"; };
Signature · 1 line
2.11.0
PATCH 2/2 ARM: dts: imx6: RDU2: disallow RMI4 device sleep
This is causing issues with some specific controller configurations, as the platform isn't power limited it's better to keep it disabled.
--- arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi +1 -1
@@ -608,7 +608,7 @@ rmi4-f01 at 1 { reg = <0x1>; - syna,nosleep-mode = <1>; + syna,nosleep-mode = <2>; }; rmi4-f11 at 11 {
Signature · 1 line
2.11.0
PATCH 2/2 ARM: dts: imx6: RDU2: disallow RMI4 device sleep
This patch has been successfully tested on the RDU2 platform and addresses the issues that occur with touchscreen firmware power management enabled.
Quoted 24 lines · Lucas Stach
This is causing issues with some specific controller configurations, as the platform isn't power limited it's better to keep it disabled.
Signed-off-by Lucas Stach <[email protected]>--- arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi +1
-2@@ -608,7 +608,7 @@ rmi4-f01 at 1 { reg = <0x1>; - syna,nosleep-mode = <1>; + syna,nosleep-mode = <2>; }; rmi4-f11 at 11 { --2.11.0
Shawn Guo
AppliedPATCH 1/2 ARM: dts: imx6: RDU2: disable over-current detection on USB H1
In reply to Lucas StachQuoted 3 lines · Lucas Stach
Just like the OTG port, USB H1 has no over-current detection wired up.
Signed-off-by Lucas Stach <[email protected]>
Applied both, thanks.