ARM: dts: meson: enabling the USB Host controller on Odroid-C1/C1+ board
Subsystems (2)
PATCH 1/1 ARM: dts: meson: enabling the USB Host controller on Odroid-C1/C1+ board
This patch enables the USB Host controller (USB1) and the relative USB2 PHY on Odroid-C1/C1+ board.
--- arch/arm/boot/dts/meson8b-odroidc1.dts | 23 +++++++++++++++++++++++ 1 file changed, 23 insertions(+)
arch/arm/boot/dts/meson8b-odroidc1.dts +23 -0
@@ -76,3 +76,26 @@ pinctrl-0 = <&uart_ao_a_pins>; pinctrl-names = "default"; }; + +&gpio_ao { + /* + * WARNING: The USB Hub on the Odroid-C1/C1+ needs a reset signal + * to be turned high in order to be detected by the USB Controller. + * This signal should be handled by a USB specific power sequence + * in order to reset the Hub when USB bus is powered down. + */ + usb-hub { + gpio-hog; + gpios = <GPIOAO_4 GPIO_ACTIVE_HIGH>; + output-high; + line-name = "usb-hub-reset"; + }; +}; + +&usb1_phy { + status = "okay"; +}; + +&usb1 { + status = "okay"; +};
Signature · 1 line
2.14.1
Martin Blumenstingl
reviewerPATCH 1/1 ARM: dts: meson: enabling the USB Host controller on Odroid-C1/C1+ board
Quoted 4 lines · Emiliano Ingrassia
This patch enables the USB Host controller (USB1) and the relative USB2 PHY on Odroid-C1/C1+ board.
Signed-off-by Emiliano Ingrassia <[email protected]>
I don't have any Odroid hardware to play with, but this looks good to me:
Quoted 43 lines
--- arch/arm/boot/dts/meson8b-odroidc1.dts | 23 +++++++++++++++++++++++ 1 file changed, 23 insertions(+)arch/arm/boot/dts/meson8b-odroidc1.dts +23
-1@@ -76,3 +76,26 @@ pinctrl-0 = <&uart_ao_a_pins>; pinctrl-names = "default"; }; + +&gpio_ao { + /* + * WARNING: The USB Hub on the Odroid-C1/C1+ needs a reset signal + * to be turned high in order to be detected by the USB Controller. + * This signal should be handled by a USB specific power sequence + * in order to reset the Hub when USB bus is powered down. + */ + usb-hub { + gpio-hog; + gpios = <GPIOAO_4 GPIO_ACTIVE_HIGH>; + output-high; + line-name = "usb-hub-reset"; + }; +}; + +&usb1_phy { + status = "okay"; +}; + +&usb1 { + status = "okay"; +}; --2.14.1
_______________________________________________
linux-amlogic mailing list
linux-amlogic at lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-amlogic
Quoted 4 lines
This patch enables the USB Host controller (USB1) and the relative USB2 PHY on Odroid-C1/C1+ board.
Signed-off-by Emiliano Ingrassia <[email protected]>
As the freezes seems to be caused by something else and stress-ng works fine for me now on an Odroid C1+ (at least with the reserved memory regions):
Cheers
Kevin Hilman
maintainerPATCH 1/1 ARM: dts: meson: enabling the USB Host controller on Odroid-C1/C1+ board
In reply to Emiliano IngrassiaQuoted 4 lines · Emiliano Ingrassia
This patch enables the USB Host controller (USB1) and the relative USB2 PHY on Odroid-C1/C1+ board.
Signed-off-by Emiliano Ingrassia <[email protected]>
Appled to v4.15/dt,
Thanks,
Kevin