Revert "net: dsa: bcm_sf2: Defer port enabling to calling port_enable"

This reverts commit e85ec74ace29 ("net: dsa: bcm_sf2: Defer port enabling to calling port_enable") because this now makes an unbind followed by a bind to fail connecting to the ingrated PHY.

What this patch missed is that we need the PHY to be enabled with bcm_sf2_gphy_enable_set() before probing it on the MDIO bus. This is correctly done in the ops->setup() function, but by the time ops->port_enable() runs, this is too late. Upon unbind we would power down the PHY, and so when we would bind again, the PHY would be left powered off.

---
 drivers/net/dsa/bcm_sf2.c | 9 ++++++---
 1 file changed, 6 insertions(+), 3 deletions(-)

index 898d5642b516..7aecc98d0a18 100644
@@ -754,11 +754,14 @@ static int bcm_sf2_sw_setup(struct dsa_switch *ds)
 	struct bcm_sf2_priv *priv = bcm_sf2_to_priv(ds);
 	unsigned int port;
 
-	/* Disable unused ports and configure IMP port */
+	/* Enable all valid ports and disable those unused */
 	for (port = 0; port < priv->hw_params.num_ports; port++) {
-		if (dsa_is_cpu_port(ds, port))
+		/* IMP port receives special treatment */
+		if ((1 << port) & ds->enabled_port_mask)
+			bcm_sf2_port_setup(ds, port, NULL);
+		else if (dsa_is_cpu_port(ds, port))
 			bcm_sf2_imp_setup(ds, port);
-		else if (!((1 << port) & ds->enabled_port_mask))
+		else
 			bcm_sf2_port_disable(ds, port, NULL);
 	}
 

2.9.3

From: Florian Fainelli <[email protected]>
Date: Thu, 28 Sep 2017 11:19:06 -0700

Applied.