Skip to contentSkip to conversation

ARM: dts: imx: add ZII RDU1 board

PATCH New Lucas Stach 4 participants 4 messages Oct 18, 2017 – Oct 23, 2017

Subsystems (3)
Device tree bindings Arm i.MX and Layerscape Arm and arm64 SoC sub-architectures (common parts)
lore
Share & tools
lore

Lucas Stach

author
#0 lore raw

PATCH v2 1/1 ARM: dts: imx: add ZII RDU1 board

This adds support for the Zodiac Inflight Innovations RDU1 board, which is based on the i.MX51.

It is the predecessor of the already supported ZII RDU2 board and relies on the bootloader in the same way to enable correct display and touchscreen nodes.

Signed-off-by Lucas Stach <[email protected]>

---
v2:
- rebase on top of Shawn's imx/dt branch and fix display nodes
- remove usbphy unit address
- remove fsl,spi-num-chipselects property

---
 arch/arm/boot/dts/Makefile           |   3 +-
 arch/arm/boot/dts/imx51-zii-rdu1.dts | 834 +++++++++++++++++++++++++++++++++++
 2 files changed, 836 insertions(+), 1 deletion(-)
 create mode 100644 arch/arm/boot/dts/imx51-zii-rdu1.dts
arch/arm/boot/dts/Makefile +2 -1
index faf46abaa4a2..60b69290a5d0 100644
@@ -341,7 +341,8 @@ dtb-$(CONFIG_SOC_IMX51) += \
 	imx51-babbage.dtb \
 	imx51-digi-connectcore-jsk.dtb \
 	imx51-eukrea-mbimxsd51-baseboard.dtb \
-	imx51-ts4800.dtb
+	imx51-ts4800.dtb \
+	imx51-zii-rdu1.dtb
 dtb-$(CONFIG_SOC_IMX53) += \
 	imx53-ard.dtb \
 	imx53-cx9020.dtb \
arch/arm/boot/dts/imx51-zii-rdu1.dts new file +834 -0

834 lines not on this page · raw message

Signature · 1 line
2.11.0
#1 lore raw

PATCH v2 1/1 ARM: dts: imx: add ZII RDU1 board

Quoted 8 lines

This adds support for the Zodiac Inflight Innovations RDU1 board, which is based on the i.MX51.

It is the predecessor of the already supported ZII RDU2 board and relies on the bootloader in the same way to enable correct display and touchscreen nodes.

Signed-off-by Lucas Stach <[email protected]>
Tested-by Nikita Yushchenko <[email protected]>

Board boots ok. DSA works. Display works.

Applied
#3 lore raw

PATCH v2 1/1 ARM: dts: imx: add ZII RDU1 board

In reply to Lucas Stach
Quoted 8 lines · Lucas Stach

This adds support for the Zodiac Inflight Innovations RDU1 board, which is based on the i.MX51.

It is the predecessor of the already supported ZII RDU2 board and relies on the bootloader in the same way to enable correct display and touchscreen nodes.

Signed-off-by Lucas Stach <[email protected]>

Applied, thanks.