44x/fsp2: interrupt handling setup
Subsystems (2)
PATCH v2 2/4 44x/fsp2: interrupt handling setup
* clear out any possible plb6 errors
* board interrupt handling setup within l2 reg set
* fsp2 parity error setup
All those points are needed for correct interrupt handling on board level including error handling report.
Reviewed-by Alistair Popple <[email protected]>
Signed-off-by Ivan Mikhaylov <[email protected]>
--- arch/powerpc/platforms/44x/fsp2.c | 37 +++++++++++++++++++++++++++++++++++++ 1 files changed, 37 insertions(+), 0 deletions(-)
arch/powerpc/platforms/44x/fsp2.c +37 -0
@@ -27,6 +27,8 @@#include <asm/time.h> #include <asm/uic.h> #include <asm/ppc4xx.h> +#include <asm/dcr.h> +#include "fsp2.h" static __initdata struct of_device_id fsp2_of_bus[] = { { .compatible ="ibm,plb4" , },
@@ -44,10 +46,45 @@ static int __init fsp2_device_probe(void)static int __init fsp2_probe (void ) { +u32 val;unsigned long root =of_get_flat_dt_root ();if (!of_flat_dt_is_compatible (root,"ibm,fsp2" ))return 0 ; + +/* Clear BC_ERR and mask snoopable request plb errors. */ + val =mfdcr (DCRN_PLB6_CR0 ); + val |=0x20000000 ; +mtdcr (DCRN_PLB6_BASE , val); +mtdcr (DCRN_PLB6_HD ,0xffff0000 ); +mtdcr (DCRN_PLB6_SHD ,0xffff0000 ); + +/* L2 machine checks */ +mtl2 (L2PLBMCKEN0 ,0xffffffff ); +mtl2 (L2PLBMCKEN1 ,0x0000ffff ); +mtl2 (L2ARRMCKEN0 ,0xffffffff ); +mtl2 (L2ARRMCKEN1 ,0xffffffff ); +mtl2 (L2ARRMCKEN2 ,0xfffff000 ); +mtl2 (L2CPUMCKEN ,0xffffffff ); +mtl2 (L2RACMCKEN0 ,0xffffffff ); +mtl2 (L2WACMCKEN0 ,0xffffffff ); +mtl2 (L2WACMCKEN1 ,0xffffffff ); +mtl2 (L2WACMCKEN2 ,0xffffffff ); +mtl2 (L2WDFMCKEN ,0xffffffff ); + +/* L2 interrupts */ +mtl2 (L2PLBINTEN1 ,0xffff0000 ); + +/* +* At a global level, enable all L2 machine checks and interrupts +* reported by the L2 subsystems, except for the external machine check +* input (UIC0.1). +*/ +mtl2 (L2MCKEN ,0x000007ff ); +mtl2 (L2INTEN ,0x000004ff ); + +/* Enable FSP-2 configuration logic parity errors */ +mtdcr (DCRN_CONF_EIR_RS ,0x80000000 );return 1 ; }
Signature · 1 line
1.7.1