Skip to contentSkip to conversation

ARM: dts: imx7s-warp: enable uart6 on mikroBus

PATCH New Ryan Harkin 3 participants 3 messages Jan 23, 2018 – Feb 5, 2018

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 ARM: dts: imx7s-warp: enable uart6 on mikroBus

This patch configures the board to output UART6 to the mikroBus.

The NXP WaRP7 board can route UART6 to the mikroBus, where an RS232 click board can be plugged in to get an additional serial port.

---
 arch/arm/boot/dts/imx7s-warp.dts | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)
arch/arm/boot/dts/imx7s-warp.dts +16 -0
index 9bdf121..1606713 100644
@@ -271,6 +271,15 @@
 	status = "okay";
 };
 
+&uart6 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pinctrl_uart6>;
+	assigned-clocks = <&clks IMX7D_UART6_ROOT_SRC>;
+	assigned-clock-parents = <&clks IMX7D_PLL_SYS_MAIN_240M_CLK>;
+	fsl,dte-mode;
+	status = "okay";
+};
+
 &usbotg1 {
 	dr_mode = "peripheral";
 	status = "okay";
@@ -379,6 +388,13 @@
 		>;
 	};
 
+	pinctrl_uart6: uart6grp {
+		fsl,pins = <
+			MX7D_PAD_ECSPI1_MOSI__UART6_DTE_RX	0x79
+			MX7D_PAD_ECSPI1_SCLK__UART6_DTE_TX	0x79
+		>;
+	};
+
 	pinctrl_usdhc1: usdhc1grp {
 		fsl,pins = <
 			MX7D_PAD_SD1_CMD__SD1_CMD	0x59
Signature · 1 line
2.7.4