Skip to contentSkip to conversation

net: thunderbolt: Tear down connection properly on suspend

PATCH Applied Mika Westerberg 2 participants 4 messages Feb 12, 2018

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/2 net: thunderbolt: Tear down connection properly on suspend

When suspending to mem or disk the Thunderbolt controller typically goes down as well tearing down the connection automatically. However, when suspend to idle is used this does not happen so we need to make sure the connection is properly disconnected before it can be re-established during resume.

Fixes e69b6c02b4c3 ("net: Add support for networking over Thunderbolt cable")
---
 drivers/net/thunderbolt.c | 5 +----
 1 file changed, 1 insertion(+), 4 deletions(-)
drivers/net/thunderbolt.c +1 -4
index ca5e375de27c..71cf9ab72fbc 100644
@@ -1270,10 +1270,7 @@ static int __maybe_unused tbnet_suspend(struct device *dev)
 	stop_login(net);
 	if (netif_running(net->dev)) {
 		netif_device_detach(net->dev);
-		tb_ring_stop(net->rx_ring.ring);
-		tb_ring_stop(net->tx_ring.ring);
-		tbnet_free_buffers(&net->rx_ring);
-		tbnet_free_buffers(&net->tx_ring);
+		tbnet_tear_down(net, true);
 	}
 
 	return 0;
Signature · 1 line
2.15.1
#1 lore raw

PATCH 2/2 net: thunderbolt: Run disconnect flow asynchronously when logout is received

The control channel calls registered callbacks when control messages such as XDomain protocol messages are received. The control channel handling is done in a worker running on system workqueue which means the networking driver can't run tear down flow which includes sending disconnect request and waiting for a reply in the same worker. Otherwise reply is never received (as the work is already running) and the operation times out.

To fix this run disconnect ThunderboltIP flow asynchronously once ThunderboltIP logout message is received.

Fixes e69b6c02b4c3 ("net: Add support for networking over Thunderbolt cable")
---
 drivers/net/thunderbolt.c | 14 +++++++++++++-
 1 file changed, 13 insertions(+), 1 deletion(-)
drivers/net/thunderbolt.c +13 -1
index 71cf9ab72fbc..e0d6760f3219 100644
@@ -166,6 +166,8 @@ struct tbnet_ring {
  * @connected_work: Worker that finalizes the ThunderboltIP connection
  *		    setup and enables DMA paths for high speed data
  *		    transfers
+ * @disconnect_work: Worker that handles tearing down the ThunderboltIP
+ *		     connection
  * @rx_hdr: Copy of the currently processed Rx frame. Used when a
  *	    network packet consists of multiple Thunderbolt frames.
  *	    In host byte order.
@@ -190,6 +192,7 @@ struct tbnet {
 	int login_retries;
 	struct delayed_work login_work;
 	struct work_struct connected_work;
+	struct work_struct disconnect_work;
 	struct thunderbolt_ip_frame_header rx_hdr;
 	struct tbnet_ring rx_ring;
 	atomic_t frame_id;
@@ -445,7 +448,7 @@ static int tbnet_handle_packet(const void *buf, size_t size, void *data)
 	case TBIP_LOGOUT:
 		ret = tbnet_logout_response(net, route, sequence, command_id);
 		if (!ret)
-			tbnet_tear_down(net, false);
+			queue_work(system_long_wq, &net->disconnect_work);
 		break;
 
 	default:
@@ -659,6 +662,13 @@ static void tbnet_login_work(struct work_struct *work)
 	}
 }
 
+static void tbnet_disconnect_work(struct work_struct *work)
+{
+	struct tbnet *net = container_of(work, typeof(*net), disconnect_work);
+
+	tbnet_tear_down(net, false);
+}
+
 static bool tbnet_check_frame(struct tbnet *net, const struct tbnet_frame *tf,
 			      const struct thunderbolt_ip_frame_header *hdr)
 {
@@ -881,6 +891,7 @@ static int tbnet_stop(struct net_device *dev)
 
 	napi_disable(&net->napi);
 
+	cancel_work_sync(&net->disconnect_work);
 	tbnet_tear_down(net, true);
 
 	tb_ring_free(net->rx_ring.ring);
@@ -1195,6 +1206,7 @@ static int tbnet_probe(struct tb_service *svc, const struct tb_service_id *id)
 	net = netdev_priv(dev);
 	INIT_DELAYED_WORK(&net->login_work, tbnet_login_work);
 	INIT_WORK(&net->connected_work, tbnet_connected_work);
+	INIT_WORK(&net->disconnect_work, tbnet_disconnect_work);
 	mutex_init(&net->connection_lock);
 	atomic_set(&net->command_id, 0);
 	atomic_set(&net->frame_id, 0);
Signature · 1 line
2.15.1
maintainer
#2 lore raw

Re: [PATCH net 2/2] net: thunderbolt: Run disconnect flow asynchronously when logout is received

From: Mika Westerberg <[email protected]>
Date: Mon, 12 Feb 2018 17:10:20 +0300

Quoted 8 lines

The control channel calls registered callbacks when control messages such as XDomain protocol messages are received. The control channel handling is done in a worker running on system workqueue which means the networking driver can't run tear down flow which includes sending disconnect request and waiting for a reply in the same worker. Otherwise reply is never received (as the work is already running) and the operation times out.

Quoted 5 lines

To fix this run disconnect ThunderboltIP flow asynchronously once ThunderboltIP logout message is received.

Fixes e69b6c02b4c3 ("net: Add support for networking over Thunderbolt cable")

Also applied, thank you.

maintainer Applied
#3 lore raw
In reply to Mika Westerberg

From: Mika Westerberg <[email protected]>
Date: Mon, 12 Feb 2018 17:10:19 +0300

Quoted 8 lines

When suspending to mem or disk the Thunderbolt controller typically goes down as well tearing down the connection automatically. However, when suspend to idle is used this does not happen so we need to make sure the connection is properly disconnected before it can be re-established during resume.

Fixes e69b6c02b4c3 ("net: Add support for networking over Thunderbolt cable")

Applied.