ARM: dts: rockchip: add power key for Rock2 Square
Subsystems (2)
PATCH 1/3 ARM: dts: rockchip: add power key for Rock2 Square
Support the power button on Radxa Rock2 Square.
--- arch/arm/boot/dts/rk3288-rock2-square.dts | 20 ++++++++++++++++++++ 1 file changed, 20 insertions(+)
arch/arm/boot/dts/rk3288-rock2-square.dts +20 -0
@@ -39,6 +39,7 @@ */ /dts-v1/; +#include <dt-bindings/input/input.h> #include "rk3288-rock2-som.dtsi" / {
@@ -49,6 +50,19 @@ stdout-path = "serial2:115200n8"; }; + gpio-keys { + compatible = "gpio-keys"; + + power { + gpios = <&gpio0 RK_PA5 GPIO_ACTIVE_LOW>; + label = "GPIO Power"; + linux,code = <KEY_POWER>; + pinctrl-names = "default"; + pinctrl-0 = <&pwr_key>; + wakeup-source; + }; + }; + gpio-leds { compatible = "gpio-leds";
@@ -220,6 +234,12 @@ }; }; + keys { + pwr_key: pwr-key { + rockchip,pins = <0 5 RK_FUNC_GPIO &pcfg_pull_up>; + }; + }; + pmic { pmic_int: pmic-int { rockchip,pins = <0 4 RK_FUNC_GPIO &pcfg_pull_up>;
Signature · 1 line
2.16.1
PATCH 2/3 ARM: dts: rockchip: add recovery button for Rock2 Square
The recovery button is connected to ADC1. This is the same setup as the Firefly board, but for Rock2 the power supply is connected on the module and all of the inputs are wired up to the edge connector, so use of the ADC depends on the carrier board.
--- arch/arm/boot/dts/rk3288-rock2-som.dtsi | 4 ++++ arch/arm/boot/dts/rk3288-rock2-square.dts | 17 +++++++++++++++++ 2 files changed, 21 insertions(+)
arch/arm/boot/dts/rk3288-rock2-som.dtsi +4 -0
@@ -280,6 +280,10 @@ }; }; +&saradc { + vref-supply = <&vcc_18>; +}; + &tsadc { rockchip,hw-tshut-mode = <0>; /* tshut mode 0:CRU 1:GPIO */ rockchip,hw-tshut-polarity = <0>; /* tshut polarity 0:LOW 1:HIGH */
arch/arm/boot/dts/rk3288-rock2-square.dts +17 -0
@@ -50,6 +50,19 @@ stdout-path = "serial2:115200n8"; }; + adc-keys { + compatible = "adc-keys"; + io-channels = <&saradc 1>; + io-channel-names = "buttons"; + keyup-threshold-microvolt = <1800000>; + + button-recovery { + label = "Recovery"; + linux,code = <KEY_VENDOR>; + press-threshold-microvolt = <0>; + }; + }; + gpio-keys { compatible = "gpio-keys";
@@ -281,6 +294,10 @@ }; }; +&saradc { + status = "okay"; +}; + &spdif { status = "okay"; };
Signature · 1 line
2.16.1
PATCH 3/3 ARM: dts: rockchip: enable USB-OTG port on Radxa Rock2 Square
In reply to John KeepingThis allows the USB gadget framework to be used on Rock2 Square.
--- arch/arm/boot/dts/rk3288-rock2-square.dts | 4 ++++ 1 file changed, 4 insertions(+)
arch/arm/boot/dts/rk3288-rock2-square.dts +4 -0
@@ -321,3 +321,7 @@ &usb_host1 { status = "okay"; }; + +&usb_otg { + status = "okay"; +};
Signature · 1 line
2.16.1
Heiko Stuebner
maintainerPATCH 1/3 ARM: dts: rockchip: add power key for Rock2 Square
In reply to John KeepingAm Sonntag, 18. Februar 2018, 18:03:34 CET schrieb John Keeping:
Quoted 3 lines
Support the power button on Radxa Rock2 Square.
Signed-off-by John Keeping <[email protected]>
applied all 3 patches for 4.17
Thanks
Heiko