Skip to contentSkip to conversation

ixgbe: check for 128-bit authentication

PATCH New Jeff Kirsher 1 participant 3 messages Feb 26, 2018

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/3 ixgbe: check for 128-bit authentication

From: Shannon Nelson <[email protected]>

Make sure the Security Association is using
a 128-bit authentication, since that's the only
size that the hardware offload supports.

---
 drivers/net/ethernet/intel/ixgbe/ixgbe_ipsec.c | 16 +++++++++++-----
 drivers/net/ethernet/intel/ixgbe/ixgbe_ipsec.h |  1 +
 2 files changed, 12 insertions(+), 5 deletions(-)
drivers/net/ethernet/intel/ixgbe/ixgbe_ipsec.c +11 -5
index 93eacddb6704..8b7dbc8057eb 100644
@@ -423,15 +423,21 @@ static int ixgbe_ipsec_parse_proto_keys(struct xfrm_state *xs,
 	const char aes_gcm_name[] = "rfc4106(gcm(aes))";
 	int key_len;
 
-	if (xs->aead) {
-		key_data = &xs->aead->alg_key[0];
-		key_len = xs->aead->alg_key_len;
-		alg_name = xs->aead->alg_name;
-	} else {
+	if (!xs->aead) {
 		netdev_err(dev, "Unsupported IPsec algorithm\n");
 		return -EINVAL;
 	}
 
+	if (xs->aead->alg_icv_len != IXGBE_IPSEC_AUTH_BITS) {
+		netdev_err(dev, "IPsec offload requires %d bit authentication\n",
+			   IXGBE_IPSEC_AUTH_BITS);
+		return -EINVAL;
+	}
+
+	key_data = &xs->aead->alg_key[0];
+	key_len = xs->aead->alg_key_len;
+	alg_name = xs->aead->alg_name;
+
 	if (strcmp(alg_name, aes_gcm_name)) {
 		netdev_err(dev, "Unsupported IPsec algorithm - please use %s\n",
 			   aes_gcm_name);
drivers/net/ethernet/intel/ixgbe/ixgbe_ipsec.h +1 -0
index 9c00e413c8e9..4f099f516645 100644
@@ -33,6 +33,7 @@
 #define IXGBE_IPSEC_MAX_RX_IP_COUNT	128
 #define IXGBE_IPSEC_BASE_RX_INDEX	0
 #define IXGBE_IPSEC_BASE_TX_INDEX	IXGBE_IPSEC_MAX_SA_COUNT
+#define IXGBE_IPSEC_AUTH_BITS		128
 
 #define IXGBE_RXTXIDX_IPS_EN		0x00000001
 #define IXGBE_RXIDX_TBL_SHIFT		1
Signature · 1 line
2.14.3
#1 lore raw

PATCH 2/3 ixgbe: fix ipsec trailer length

From: Shannon Nelson <[email protected]>

Fix up the Tx trailer length calculation. We can't believe the trailer len from the xstate information because it was calculated before the packet was put together and padding added. This bit of code finds the padding value in the trailer, adds it to the authentication length, and saves it so later we can put it into the Tx descriptor to tell the device where to stop the checksum calculation.

Fixes 592594704761 ("ixgbe: process the Tx ipsec offload")
---
 drivers/net/ethernet/intel/ixgbe/ixgbe_ipsec.c | 24 +++++++++++++++++++++++-
 1 file changed, 23 insertions(+), 1 deletion(-)
drivers/net/ethernet/intel/ixgbe/ixgbe_ipsec.c +23 -1
index 8b7dbc8057eb..8623013e517e 100644
@@ -789,11 +789,33 @@ int ixgbe_ipsec_tx(struct ixgbe_ring *tx_ring,
 
 	itd->flags = 0;
 	if (xs->id.proto == IPPROTO_ESP) {
+		struct sk_buff *skb = first->skb;
+		int ret, authlen, trailerlen;
+		u8 padlen;
+
 		itd->flags |= IXGBE_ADVTXD_TUCMD_IPSEC_TYPE_ESP |
 			      IXGBE_ADVTXD_TUCMD_L4T_TCP;
 		if (first->protocol == htons(ETH_P_IP))
 			itd->flags |= IXGBE_ADVTXD_TUCMD_IPV4;
-		itd->trailer_len = xs->props.trailer_len;
+
+		/* The actual trailer length is authlen (16 bytes) plus
+		 * 2 bytes for the proto and the padlen values, plus
+		 * padlen bytes of padding.  This ends up not the same
+		 * as the static value found in xs->props.trailer_len (21).
+		 *
+		 * The "correct" way to get the auth length would be to use
+		 *    authlen = crypto_aead_authsize(xs->data);
+		 * but since we know we only have one size to worry about
+		 * we can let the compiler use the constant and save us a
+		 * few CPU cycles.
+		 */
+		authlen = IXGBE_IPSEC_AUTH_BITS / 8;
+
+		ret = skb_copy_bits(skb, skb->len - (authlen + 2), &padlen, 1);
+		if (unlikely(ret))
+			return 0;
+		trailerlen = authlen + 2 + padlen;
+		itd->trailer_len = trailerlen;
 	}
 	if (tsa->encrypt)
 		itd->flags |= IXGBE_ADVTXD_TUCMD_IPSEC_ENCRYPT_EN;
Signature · 1 line
2.14.3
#2 lore raw

PATCH 3/3 ixgbe: remove unneeded ipsec state free callback

In reply to Jeff Kirsher

From: Shannon Nelson <[email protected]>

With commit 7f05b467a735 ("xfrm: check for xdo_dev_state_free") we no longer need to add an empty callback function to the driver, so now let's remove the useless code.

---
 drivers/net/ethernet/intel/ixgbe/ixgbe_ipsec.c | 13 -------------
 1 file changed, 13 deletions(-)
drivers/net/ethernet/intel/ixgbe/ixgbe_ipsec.c +0 -13
index 8623013e517e..f2254528dcfc 100644
@@ -724,23 +724,10 @@ static bool ixgbe_ipsec_offload_ok(struct sk_buff *skb, struct xfrm_state *xs)
 	return true;
 }
 
-/**
- * ixgbe_ipsec_free - called by xfrm garbage collections
- * @xs: pointer to transformer state struct
- *
- * We don't have any garbage to collect, so we shouldn't bother
- * implementing this function, but the XFRM code doesn't check for
- * existence before calling the API callback.
- **/
-static void ixgbe_ipsec_free(struct xfrm_state *xs)
-{
-}
-
 static const struct xfrmdev_ops ixgbe_xfrmdev_ops = {
 	.xdo_dev_state_add = ixgbe_ipsec_add_sa,
 	.xdo_dev_state_delete = ixgbe_ipsec_del_sa,
 	.xdo_dev_offload_ok = ixgbe_ipsec_offload_ok,
-	.xdo_dev_state_free = ixgbe_ipsec_free,
 };
 
 /**
Signature · 1 line
2.14.3