ARM: dts: omap4-droid4: Fix USB PHY port naming

@@ -71,8 +71,8 @@
 		regulator-always-on;
 	};
 
-	/* HS USB Host PHY on PORT 1 */
-	hsusb1_phy: hsusb1_phy {
+	/* HS USB host TLL nop-phy on port 2 for w3glte */
+	hsusb2_phy: usb-phy@2 {
 		compatible = "usb-nop-xceiv";
 		#phy-cells = <0>;
 	};

@@ -584,7 +584,7 @@
 };
 
 &usbhsehci {
-	phys = <&hsusb1_phy>;
+	phys = <&hsusb2_phy>;
 };
 
 &usbhshost {

@@ -71,6 +71,28 @@
 		regulator-always-on;
 	};
 
+	/* FS USB Host PHY on port 1 for mdm6600 */
+	fsusb1_phy: usb-phy@1 {
+		compatible = "motorola,mapphone-mdm6600";
+		pinctrl-0 = <&usb_mdm6600_pins>;
+		pinctrl-names = "default";
+		enable-gpios = <&gpio3 31 GPIO_ACTIVE_LOW>;     /* gpio_95 */
+		power-gpios = <&gpio2 22 GPIO_ACTIVE_HIGH>;	/* gpio_54 */
+		reset-gpios = <&gpio2 17 GPIO_ACTIVE_HIGH>;	/* gpio_49 */
+		/* mode: gpio_148 gpio_149 */
+		motorola,mode-gpios = <&gpio5 20 GPIO_ACTIVE_HIGH>,
+				      <&gpio5 21 GPIO_ACTIVE_HIGH>;
+		/* cmd: gpio_103 gpio_104 gpio_142 */
+		motorola,cmd-gpios = <&gpio4 7 GPIO_ACTIVE_HIGH>,
+				     <&gpio4 8 GPIO_ACTIVE_HIGH>,
+				     <&gpio5 14 GPIO_ACTIVE_HIGH>;
+		/* status: gpio_52 gpio_53 gpio_55 */
+		motorola,status-gpios = <&gpio2 20 GPIO_ACTIVE_HIGH>,
+					<&gpio2 21 GPIO_ACTIVE_HIGH>,
+					<&gpio2 23 GPIO_ACTIVE_HIGH>;
+		#phy-cells = <0>;
+	};
+
 	/* HS USB host TLL nop-phy on port 2 for w3glte */
 	hsusb2_phy: usb-phy@2 {
 		compatible = "usb-nop-xceiv";

@@ -459,6 +481,43 @@
 		>;
 	};
 
+	usb_mdm6600_pins: pinmux_usb_mdm6600_pins {
+		pinctrl-single,pins = <
+		/* enable 0x4a1000d8 usbb1_ulpitll_dat7.gpio_95 ag16 */
+		OMAP4_IOPAD(0x0d8, PIN_INPUT | MUX_MODE3)
+
+		/* power 0x4a10007c gpmc_nwp.gpio_54 c25 */
+		OMAP4_IOPAD(0x07c, PIN_OUTPUT | MUX_MODE3)
+
+		/* reset 0x4a100072 gpmc_a25.gpio_49 d20 */
+		OMAP4_IOPAD(0x072, PIN_OUTPUT | MUX_MODE3)
+
+		/* mode0/bpwake 0x4a10014e sdmmc5_dat1.gpio_148 af4 */
+		OMAP4_IOPAD(0x14e, PIN_OUTPUT | MUX_MODE3)
+
+		/* mode1/apwake 0x4a100150 sdmmc5_dat2.gpio_149 ag3 */
+		OMAP4_IOPAD(0x150, PIN_OFF_OUTPUT_LOW | PIN_INPUT | MUX_MODE3)
+
+		/* status0 0x4a10007e gpmc_clk.gpio_55 b22 */
+		OMAP4_IOPAD(0x07e, PIN_INPUT | MUX_MODE3)
+
+		/* status1 0x4a10007a gpmc_ncs3.gpio_53 c22 */
+		OMAP4_IOPAD(0x07a, PIN_INPUT | MUX_MODE3)
+
+		/* status2 0x4a100078 gpmc_ncs2.gpio_52 d21 */
+		OMAP4_IOPAD(0x078, PIN_INPUT | MUX_MODE3)
+
+		/* cmd0 0x4a100094 gpmc_ncs6.gpio_103 c24 */
+		OMAP4_IOPAD(0x094, PIN_OUTPUT | MUX_MODE3)
+
+		/* cmd1 0x4a100096 gpmc_ncs7.gpio_104 d24 */
+		OMAP4_IOPAD(0x096, PIN_OUTPUT | MUX_MODE3)
+
+		/* cmd2 0x4a100142 uart3_rts_sd.gpio_142 f28 */
+		OMAP4_IOPAD(0x142, PIN_OUTPUT | MUX_MODE3)
+		>;
+	};
+
 	usb_ulpi_pins: pinmux_usb_ulpi_pins {
 		pinctrl-single,pins = <
 		OMAP4_IOPAD(0x196, MUX_MODE7)

@@ -583,6 +642,11 @@
 	};
 };
 
+&usbhsohci {
+	phys = <&fsusb1_phy>;
+	phy-names = "usb";
+};
+
 &usbhsehci {
 	phys = <&hsusb2_phy>;
 };

@@ -557,6 +557,28 @@
 		>;
 	};
 
+	/*
+	 * Note that the v3.0.8 stock userspace dynamically remuxes uart1
+	 * rts pin probably for PM purposes to PIN_INPUT_PULLUP | MUX_MODE7
+	 * when not used. If needed, we can add rts pin remux later based
+	 * on power measurements.
+	 */
+	uart1_pins: pinmux_uart1_pins {
+		pinctrl-single,pins = <
+		/* 0x4a10013c mcspi1_cs2.uart1_cts ag23 */
+		OMAP4_IOPAD(0x13c, PIN_INPUT_PULLUP | MUX_MODE1)
+
+		/* 0x4a10013e mcspi1_cs3.uart1_rts ah23 */
+		OMAP4_IOPAD(0x13e, MUX_MODE1)
+
+		/* 0x4a100140 uart3_cts_rctx.uart1_tx f27 */
+		OMAP4_IOPAD(0x140, PIN_OUTPUT | MUX_MODE1)
+
+		/* 0x4a1001ca dpm_emu14.uart1_rx aa3 */
+		OMAP4_IOPAD(0x1ca, PIN_INPUT_PULLUP | MUX_MODE2)
+		>;
+	};
+
 	/* uart3_tx_irtx and uart3_rx_irrx */
 	uart3_pins: pinmux_uart3_pins {
 		pinctrl-single,pins = <

@@ -626,6 +648,17 @@
 	};
 };
 
+/*
+ * As uart1 is wired to mdm6600 with rts and cts, we can use the cts pin for
+ * uart1 wakeirq.
+ */
+&uart1 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&uart1_pins>;
+	interrupts-extended = <&wakeupgen GIC_SPI 72 IRQ_TYPE_LEVEL_HIGH
+			       &omap4_pmx_core 0xfc>;
+};
+
 &uart3 {
 	interrupts-extended = <&wakeupgen GIC_SPI 74 IRQ_TYPE_LEVEL_HIGH
 			       &omap4_pmx_core 0x17c>;