Skip to contentSkip to conversation

regression, imx6 and sgtl5000 sound problems

DISCUSSION Mika Penttilä 2 participants 3 messages Apr 6, 2018

lore
Share & tools
lore
#0 lore raw

Hi,

With recent merge to pre 4.17-rc, audio stopped workin (or it's hearable but way too slow). imx6q + sgtl5000 codec.

Maybe some of the soc/fsl changes is causing this.

--Mika

#1 lore raw
Quoted 3 lines · Mika Penttilä

With recent merge to pre 4.17-rc, audio stopped workin (or it's hearable but way too slow). imx6q + sgtl5000 codec.

Could you please be more specific at your test cases?

Which board? Whose is the DAI master? Which sample rate?

Quoted 1 line

Maybe some of the soc/fsl changes is causing this.

There are quite a few clean-up patches of SSI driver being merged. Would you please try to revert/bisect the changes of fsl_ssi driver so as to figure out which one breaks your test cases?

If there is a regression because of one of the changes, I will need to fix it.

Thanks
Nicolin

#2 lore raw
Quoted 15 lines · Nicolin Chen
Quoted 3 lines · Mika Penttilä

With recent merge to pre 4.17-rc, audio stopped workin (or it's hearable but way too slow). imx6q + sgtl5000 codec.

Could you please be more specific at your test cases?

Which board? Whose is the DAI master? Which sample rate?

Quoted 1 line

Maybe some of the soc/fsl changes is causing this.

There are quite a few clean-up patches of SSI driver being merged. Would you please try to revert/bisect the changes of fsl_ssi driver so as to figure out which one breaks your test cases?

Quoted 6 lines

If there is a regression because of one of the changes, I will need to fix it.

Thanks
Nicolin

Hi,

We have a custom board (very near to Karo tx evkit). The test is simply aplay file.wav, at least sample rate 48kHz tested and not working. Nothing special there hw wise.

I try to bisect it and report back to you.

--Mika