Update in the description of marginal_path_err_rate_threshold

PATCH New Muneendra 1 participant 1 message May 28, 2018 Device mapper

Share & tools

Muneendra

author

2018-05-28 09:25 UTC #0 lore raw

PATCH 1/1 Update in the description of marginal_path_err_rate_threshold

The multipath.conf.5 description of marginal_path_err_rate_threshold, states that the path will not reinstate for \fImarginal_path_err_recheck_gap_time\fR seconds,
where it should be marginal_path_err_recheck_gap_time seconds.

Signed-off-by Muneendra <[email protected]>

---
 multipath/multipath.conf.5 | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

multipath/multipath.conf.5 +1 -1

index f689795..9f58520 100644
@@ -900,7 +900,7 @@ The error rate threshold as a permillage (1/1000). One of the four parameters
 of supporting path check based on accounting IO error such as intermittent
 error. Refer to \fImarginal_path_err_sample_time\fR. If the rate of IO errors
 on a particular path is greater than this parameter, then the path will not
-reinstate for \fImarginal_path_err_rate_threshold\fR seconds unless there is
+reinstate for \fImarginal_path_err_recheck_gap_time\fR seconds unless there is
 only one active path.
 .RS
 .TP

Signature · 1 line

1.8.3.1