dm: sunxi: Move Linksprite_pcDuino3_Nano to use DM for MMC, SATA
PATCH 1/2 dm: sunxi: Move Linksprite_pcDuino3_Nano to use DM for MMC, SATA
Move to the driver model for MMC and SATA, which means it implicitly uses CONFIG_BLK too.
Signed-off-by Adam Sampson <[email protected]>
---
configs/Linksprite_pcDuino3_Nano_defconfig | 2 ++ 1 file changed, 2 insertions(+)
configs/Linksprite_pcDuino3_Nano_defconfig +2 -0
@@ -15,9 +15,11 @@ CONFIG_SPL_I2C_SUPPORT=y # CONFIG_SPL_DOS_PARTITION is not set # CONFIG_SPL_EFI_PARTITION is not set CONFIG_SCSI_AHCI=y +CONFIG_DM_MMC=y CONFIG_ETH_DESIGNWARE=y CONFIG_RGMII=y CONFIG_SUN7I_GMAC=y CONFIG_SCSI=y +CONFIG_DM_SCSI=y CONFIG_USB_EHCI_HCD=y CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y
Signature · 1 line
2.18.0
PATCH 2/2 dm: sunxi: Move Cubietruck to use DM for MMC, SATA
Move to the driver model for MMC and SATA, which means it implicitly uses CONFIG_BLK too.
Signed-off-by Adam Sampson <[email protected]>
---
configs/Cubietruck_defconfig | 2 ++ 1 file changed, 2 insertions(+)
configs/Cubietruck_defconfig +2 -0
@@ -22,10 +22,12 @@ CONFIG_CMD_USB_MASS_STORAGE=y CONFIG_SCSI_AHCI=y CONFIG_DFU_RAM=y CONFIG_FASTBOOT_CMD_OEM_FORMAT=y +CONFIG_DM_MMC=y CONFIG_ETH_DESIGNWARE=y CONFIG_RGMII=y CONFIG_SUN7I_GMAC=y CONFIG_SCSI=y +CONFIG_DM_SCSI=y CONFIG_USB_EHCI_HCD=y CONFIG_USB_MUSB_GADGET=y CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y
Signature · 1 line
2.18.0
PATCH 2/2 dm: sunxi: Move Cubietruck to use DM for MMC, SATA
Quoted 4 lines · Adam Sampson
Move to the driver model for MMC and SATA, which means it implicitly uses
CONFIG_BLKtoo.Signed-off-by Adam Sampson <[email protected]>
This should be done at the Kconfig level for all the boards, so that we switch every one at once instead of having to maintain a long trail of platforms not yet converted.
Thanks!
Maxime
Signature · 3 lines
Maxime Ripard, Bootlin (formerly Free Electrons) Embedded Linux and Kernel engineering https://bootlin.com