igc: Add netdev
Subsystems (2)
PATCH v4 3/11 igc: Add netdev
Now that we have the ability to configure the basic settings on the device we can start allocating and configuring a netdev for the interface.
Sasha Neftin (v2):
add description
Sasha Neftin (v3):
minor cosmetic changes
Sasha Neftin (v4):
address comments
fix indent
replace e1000_ prefix with igc_ prefix
optimize pcie access
Signed-off-by Sasha Neftin <[email protected]>
--- drivers/net/ethernet/intel/igc/igc.h | 48 +++ drivers/net/ethernet/intel/igc/igc_defines.h | 15 + drivers/net/ethernet/intel/igc/igc_hw.h | 1 + drivers/net/ethernet/intel/igc/igc_main.c | 479 ++++++++++++++++++++++++++- 4 files changed, 540 insertions(+), 3 deletions(-)
drivers/net/ethernet/intel/igc/igc.h +48 -0
@@ -28,15 +28,63 @@extern char igc_driver_name[];extern char igc_driver_version[]; +/* Transmit and receive queues */ +#define IGC_MAX_RX_QUEUES 4 +#define IGC_MAX_TX_QUEUES 4 + +#define MAX_Q_VECTORS 10 +#define MAX_STD_JUMBO_FRAME_SIZE 9216 + +enum igc_state_t { + __IGC_TESTING, + __IGC_RESETTING, + __IGC_DOWN, + __IGC_PTP_TX_IN_PROGRESS, +}; + +struct igc_q_vector { +struct igc_adapter *adapter;/* backlink */ + +struct napi_struct napi; +}; + +struct igc_mac_addr { +u8 addr[ETH_ALEN ]; +u8 queue; +u8 state;/* bitmask */ +}; + +#define IGC_MAC_STATE_DEFAULT 0x1 +#define IGC_MAC_STATE_MODIFIED 0x2 +#define IGC_MAC_STATE_IN_USE 0x4 +/* Board specific private data structure */ struct igc_adapter { +struct net_device *netdev; + +unsigned long state; +unsigned int flags; +unsigned int num_q_vectors; +u16 link_speed; +u16 link_duplex; + +u8 port_num; +u8 __iomem *io_addr; +struct work_struct watchdog_task; + +int msg_enable; +u32 max_frame_size;/* OS defined structs */ struct pci_dev *pdev;/* structs defined in igc_hw.h */ struct igc_hw hw; + +struct igc_q_vector *q_vector[MAX_Q_VECTORS ]; + +struct igc_mac_addr *mac_table; };#endif /* _IGC_H_ */
drivers/net/ethernet/intel/igc/igc_defines.h +15 -0
@@ -4,6 +4,8 @@#ifndef _IGC_DEFINES_H_#define _IGC_DEFINES_H_ +#define IGC_CTRL_EXT_DRV_LOAD 0x10000000/* Drv loaded bit for FW */ +/* Priority on PCI. 0=rx,1=fair */ #define IGC_CTRL_PRIOR 0x00000004/* PCI Function Mask */
@@ -15,6 +17,16 @@#define PCIE_DEVICE_CONTROL2 0x28#define PCIE_DEVICE_CONTROL2_16ms 0x0005 +/* Receive Address +* Number of high/low register pairs in the RAR. The RAR (Receive Address +* Registers) holds the directed and multicast addresses that we monitor. +* Technically, we have 16 spots. However, we reserve one of these spots +* (RAR[15]) for our directed address used by controllers with +* manageability enabled, allowing us room for 15 multicast addresses. +*/ +#define IGC_RAH_AV 0x80000000/* Receive descriptor valid */ +#define IGC_RAH_POOL_1 0x00040000 +/* Error Codes */ #define IGC_SUCCESS 0#define IGC_ERR_NVM 1
@@ -24,6 +36,9 @@#define IGC_ERR_MAC_INIT 5#define IGC_ERR_RESET 9 +/* PBA constants */ +#define IGC_PBA_34K 0x0022 +/* Device Status */ #define IGC_STATUS_FD 0x00000001/* Full duplex.0=half,1=full */ #define IGC_STATUS_LU 0x00000002/* Link up.0=no,1=link */
drivers/net/ethernet/intel/igc/igc_hw.h +1 -0
@@ -84,6 +84,7 @@ struct igc_mac_info {bool autoneg;bool autoneg_failed; +bool get_link_status; };struct igc_bus_info {
drivers/net/ethernet/intel/igc/igc_main.c +476 -3
558 lines not on this page · raw message
Signature · 1 line
2.11.0