ARM: dts: imx6q-apalis: mux RESET_MOCI# signal
Subsystems (2)
PATCH 1/1 ARM: dts: imx6q-apalis: mux RESET_MOCI# signal
The pinctrl properties on the IOMUXC node get overwritten by the carrier board level device tree, hence the pinctrl_reset_moci pinctrl does not get applied.
Associate the pinctrl_reset_moci pinctrl with the PCIe node where we also make use of the pin as a reset GPIO.
Since the pin is muxed as a GPIO by default not muxing it explicitly worked fine in practise.
--- arch/arm/boot/dts/imx6q-apalis-eval.dts | 2 ++ arch/arm/boot/dts/imx6q-apalis-ixora-v1.1.dts | 2 ++ arch/arm/boot/dts/imx6q-apalis-ixora.dts | 2 ++ arch/arm/boot/dts/imx6qdl-apalis.dtsi | 4 ---- 4 files changed, 6 insertions(+), 4 deletions(-)
arch/arm/boot/dts/imx6q-apalis-eval.dts +2 -0
@@ -196,6 +196,8 @@ }; &pcie { + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_reset_moci>; /* active-high meaning opposite of regular PERST# active-low polarity */ reset-gpio = <&gpio1 28 GPIO_ACTIVE_HIGH>; reset-gpio-active-high;
arch/arm/boot/dts/imx6q-apalis-ixora-v1.1.dts +2 -0
@@ -196,6 +196,8 @@ }; &pcie { + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_reset_moci>; /* active-high meaning opposite of regular PERST# active-low polarity */ reset-gpio = <&gpio1 28 GPIO_ACTIVE_HIGH>; reset-gpio-active-high;
arch/arm/boot/dts/imx6q-apalis-ixora.dts +2 -0
@@ -200,6 +200,8 @@ }; &pcie { + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_reset_moci>; /* active-high meaning opposite of regular PERST# active-low polarity */ reset-gpio = <&gpio1 28 GPIO_ACTIVE_HIGH>; reset-gpio-active-high;
arch/arm/boot/dts/imx6qdl-apalis.dtsi +0 -4
@@ -482,10 +482,6 @@ }; &iomuxc { - /* pins used on module */ - pinctrl-names = "default"; - pinctrl-0 = <&pinctrl_reset_moci>; - pinctrl_apalis_gpio1: gpio2io04grp { fsl,pins = < MX6QDL_PAD_NANDF_D4__GPIO2_IO04 0x130b0
Signature · 1 line
2.18.0
Shawn Guo
AppliedQuoted 11 lines · Stefan Agner
The pinctrl properties on the IOMUXC node get overwritten by the carrier board level device tree, hence the
pinctrl_reset_mocipinctrl does not get applied.Associate the
pinctrl_reset_mocipinctrl with the PCIe node where we also make use of the pin as a reset GPIO.Since the pin is muxed as a GPIO by default not muxing it explicitly worked fine in practise.
Signed-off-by Stefan Agner <[email protected]>
Applied, thanks.