board: resurrect support for RIoTboard
PATCH v2 1/1 board: resurrect support for RIoTboard
Resurrect support for RIoTboard after 2018.02.x deprecation.
---
Changes v1 -> v2:
- Add board's manufacturer website for more info
- Switch to genimage sdcard image generation, update install steps in readme.txt
- Switch from uImage to zImage
- Switch rootfs to BR2_TARGET_ROOTFS_EXT2_4
- Update u-boot to v2018.07
- Update kernel to v4.18
- Add myself in DEVELOPERS for riotboard
--- DEVELOPERS | 4 +++ board/embest/riotboard/genimage.cfg | 17 +++++++++ board/embest/riotboard/readme.txt | 34 ++++++++++++++++++ .../rootfs_overlay/boot/extlinux/extlinux.conf | 6 ++++ configs/riotboard_defconfig | 41 ++++++++++++++++++++++ 5 files changed, 102 insertions(+) create mode 100644 board/embest/riotboard/genimage.cfg create mode 100644 board/embest/riotboard/readme.txt create mode 100644 board/embest/riotboard/rootfs_overlay/boot/extlinux/extlinux.conf create mode 100644 configs/riotboard_defconfig
DEVELOPERS +4 -0
@@ -1500,6 +1500,10 @@ F: package/exiv2/ F: package/nvidia-tegra23/nvidia-tegra23-binaries/ F: package/nvidia-tegra23/nvidia-tegra23-codecs/ +N: Nikolay Dimitrov <[email protected]> +F: board/embest/riotboard/ +F: configs/riotboard_defconfig + N: Nimai Mahajan <[email protected]> F: package/libucl/
board/embest/riotboard/genimage.cfg new file +17 -0
@@ -0,0 +1,17 @@ +image sdcard.img { + hdimage { + } + + partition u-boot { + in-partition-table = "no" + image = "u-boot.imx" + offset = 1024 + } + + partition rootfs { + partition-type = 0x83 + image = "rootfs.ext2" + offset = 1M + size = 60M + } +}
board/embest/riotboard/readme.txt new file +34 -0
@@ -0,0 +1,34 @@ +Buildroot for Embest RIoTboard +============================== +This is a small development board, based on Freescale IMX6 Solo SoC (single +core ARM Cortex-A9). + +More details about the board can be found here: +- http://www.embest-tech.com/riotboard + +1. Compiling buildroot +---------------------- + +make riotboard_defconfig +make + +2. Installing buildroot +----------------------- + +Prepare an SD-card and plug it into your card reader. Always double check the +block device before writing to it, as writing to the wrong block device can +cause irrecoverable data loss. Now you can write the image to your SD-card: + +sudo dd if=output/images/sdcard.img of=/dev/<sdcard-block-device> bs=1M + +3. Running buildroot +-------------------- + +Position the board so you can read the label "RIoTboard" on the right side of +SW1 DIP switches. Configure the SW1 swiches like this: + +1 0 1 0 0 1 0 1 +ON OFF ON OFF OFF ON OFF ON + +Now plug your prepared SD-card in slot J6. Connect a serial console (115200, 8, +N, 1) to header J18. Connect a 5V/1A power supply to the board and enjoy.
board/embest/riotboard/rootfs_overlay/boot/extlinux/extlinux.conf new file +6 -0
@@ -0,0 +1,6 @@ +default buildroot + +label buildroot +kernel /boot/zImage +devicetree /boot/imx6dl-riotboard.dtb +append console=ttymxc1,115200 root=/dev/mmcblk1p1 rw
configs/riotboard_defconfig new file +41 -0
41 lines not on this page · raw message
Signature · 1 line
2.11.0
Thomas Petazzoni
AppliedPATCH v2 1/1 board: resurrect support for RIoTboard
Hello,
Quoted 13 lines · Nikolay Dimitrov
Resurrect support for RIoTboard after 2018.02.x deprecation.
Signed-off-by Nikolay Dimitrov <[email protected]>---
Changes v1 -> v2:
- Add board's manufacturer website for more info
- Switch to genimage sdcard image generation, update install steps in readme.txt
- Switch from uImage to zImage
- Switch rootfs toBR2_TARGET_ROOTFS_EXT2_4
- Update u-boot to v2018.07
- Update kernel to v4.18
- Add myself in DEVELOPERS for riotboard
Quoted 11 lines
--- DEVELOPERS | 4 +++ board/embest/riotboard/genimage.cfg | 17 +++++++++ board/embest/riotboard/readme.txt | 34 ++++++++++++++++++ .../rootfs_overlay/boot/extlinux/extlinux.conf | 6 ++++ configs/riotboard_defconfig | 41 ++++++++++++++++++++++ 5 files changed, 102 insertions(+) create mode 100644 board/embest/riotboard/genimage.cfg create mode 100644 board/embest/riotboard/readme.txt create mode 100644 board/embest/riotboard/rootfs_overlay/boot/extlinux/extlinux.conf create mode 100644 configs/riotboard_defconfig
Applied to master, thanks.
Thomas
Signature · 3 lines
Thomas Petazzoni, CTO, Bootlin (formerly Free Electrons) Embedded Linux and Kernel engineering https://bootlin.com