igc: Add netdev
Subsystems (2)
PATCH v8 3/11 igc: Add netdev
Now that we have the ability to configure the basic settings on the device we can start allocating and configuring a netdev for the interface.
Sasha Neftin (v2):
add description
Sasha Neftin (v3):
minor cosmetic changes
Sasha Neftin (v4):
address comments
fix code indentation
replace e1000_ prefix with igc_ prefix
optimize pcie access
Sasha Neftin (v5):
change return value of igc_up() method to void
Sasha Neftin (v6):
fix define of MAX_Q_VECTORS
fix code indentation
minor cosmetic changes
Sasha Neftin (v7):
fix setting netdev->name
move MODULE macro defines to begin of the file
Sasha Neftin (v8):
fix whitespaces in comments
fix igc_update_stats method location
replace spaces with tab
remove unneeded blank line
fix few comments and add correct explanation of code
--- drivers/net/ethernet/intel/igc/igc.h | 48 +++ drivers/net/ethernet/intel/igc/igc_defines.h | 15 + drivers/net/ethernet/intel/igc/igc_hw.h | 1 + drivers/net/ethernet/intel/igc/igc_main.c | 471 ++++++++++++++++++++++++++- 4 files changed, 534 insertions(+), 1 deletion(-)
drivers/net/ethernet/intel/igc/igc.h +48 -0
@@ -28,15 +28,63 @@extern char igc_driver_name[];extern char igc_driver_version[]; +/* Transmit and receive queues */ +#define IGC_MAX_RX_QUEUES 4 +#define IGC_MAX_TX_QUEUES 4 + +#define MAX_Q_VECTORS 8 +#define MAX_STD_JUMBO_FRAME_SIZE 9216 + +enum igc_state_t { + __IGC_TESTING, + __IGC_RESETTING, + __IGC_DOWN, + __IGC_PTP_TX_IN_PROGRESS, +}; + +struct igc_q_vector { +struct igc_adapter *adapter;/* backlink */ + +struct napi_struct napi; +}; + +struct igc_mac_addr { +u8 addr[ETH_ALEN ]; +u8 queue; +u8 state;/* bitmask */ +}; + +#define IGC_MAC_STATE_DEFAULT 0x1 +#define IGC_MAC_STATE_MODIFIED 0x2 +#define IGC_MAC_STATE_IN_USE 0x4 +/* Board specific private data structure */ struct igc_adapter { +struct net_device *netdev; + +unsigned long state; +unsigned int flags; +unsigned int num_q_vectors; +u16 link_speed; +u16 link_duplex; + +u8 port_num; +u8 __iomem *io_addr; +struct work_struct watchdog_task; + +int msg_enable; +u32 max_frame_size;/* OS defined structs */ struct pci_dev *pdev;/* structs defined in igc_hw.h */ struct igc_hw hw; + +struct igc_q_vector *q_vector[MAX_Q_VECTORS ]; + +struct igc_mac_addr *mac_table; };#endif /* _IGC_H_ */
drivers/net/ethernet/intel/igc/igc_defines.h +15 -0
@@ -4,10 +4,22 @@#ifndef _IGC_DEFINES_H_#define _IGC_DEFINES_H_ +#define IGC_CTRL_EXT_DRV_LOAD 0x10000000/* Drv loaded bit for FW */ +/* PCI Bus Info */ #define PCIE_DEVICE_CONTROL2 0x28#define PCIE_DEVICE_CONTROL2_16ms 0x0005 +/* Receive Address +* Number of high/low register pairs in the RAR. The RAR (Receive Address +* Registers) holds the directed and multicast addresses that we monitor. +* Technically, we have 16 spots. However, we reserve one of these spots +* (RAR[15]) for our directed address used by controllers with +* manageability enabled, allowing us room for 15 multicast addresses. +*/ +#define IGC_RAH_AV 0x80000000/* Receive descriptor valid */ +#define IGC_RAH_POOL_1 0x00040000 +/* Error Codes */ #define IGC_SUCCESS 0#define IGC_ERR_NVM 1
@@ -17,6 +29,9 @@#define IGC_ERR_MAC_INIT 5#define IGC_ERR_RESET 9 +/* PBA constants */ +#define IGC_PBA_34K 0x0022 +/* Device Status */ #define IGC_STATUS_FD 0x00000001/* Full duplex.0=half,1=full */ #define IGC_STATUS_LU 0x00000002/* Link up.0=no,1=link */
drivers/net/ethernet/intel/igc/igc_hw.h +1 -0
@@ -59,6 +59,7 @@ struct igc_mac_info {bool autoneg;bool autoneg_failed; +bool get_link_status; };struct igc_bus_info {
drivers/net/ethernet/intel/igc/igc_main.c +470 -1
550 lines not on this page · raw message
Signature · 1 line
2.11.0
Brown
PATCH v8 3/11 igc: Add netdev
Quoted 40 lines
From: Intel-wired-lan [mailto:intel-wired-lan-bounces at osuosl.org] On Behalf Of Sasha Neftin
Sent: Thursday, October 11, 2018 12:17 AM
To: Neftin, Sasha <[email protected]>; intel-wired-lan at lists.osuosl.org
Subject: [Intel-wired-lan] [PATCH v8 03/11] igc: Add netdevNow that we have the ability to configure the basic settings on the device we can start allocating and configuring a netdev for the interface.
Sasha Neftin (v2):
add descriptionSasha Neftin (v3):
minor cosmetic changesSasha Neftin (v4):
address comments
fix code indentation
replacee1000_prefix withigc_prefix
optimize pcie accessSasha Neftin (v5):
change return value ofigc_up()method to voidSasha Neftin (v6):
fix define ofMAX_Q_VECTORS
fix code indentation
minor cosmetic changesSasha Neftin (v7):
fix settingnetdev->name
move MODULE macro defines to begin of the fileSasha Neftin (v8):
fix whitespaces in comments
fixigc_update_statsmethod location
replace spaces with tab
remove unneeded blank line
fix few comments and add correct explanation of code
Quoted 9 lines
Signed-off-by Sasha Neftin <[email protected]>--- drivers/net/ethernet/intel/igc/igc.h | 48 +++ drivers/net/ethernet/intel/igc/igc_defines.h | 15 + drivers/net/ethernet/intel/igc/igc_hw.h | 1 + drivers/net/ethernet/intel/igc/igc_main.c | 471 ++++++++++++++++++++++++++- 4 files changed, 534 insertions(+), 1 deletion(-)