arm: ls1021a: Add timer_init() in board_init_f for SPL
PATCH 1/1 arm: ls1021a: Add timer_init() in board_init_f for SPL
I2C is used to access DDR SPD in the DDR initialization for SPL. In i2c_write process, get_timer() will be called. In board_init_f for SPL, timer_init() is not called before. The system counter is not enabled and the counter frequency is not set to 12.5MHz in SPL. The parameters for do_div() are zero too.
It could not be found until CONFIG_USE_PRIVATE_LIBGCC is enabled in default. When CONFIG_USE_PRIVATE_LIBGCC is enabled, U-Boot will use its own set of libgcc functions. As the parameters for do_div() are zero, __div0 will be called. Then the processor will stay in an endless loop after calling hang().
This patch will add timer_init() in board_init_f for SPL and fix a series of issues it caused.
--- board/freescale/ls1021aqds/ls1021aqds.c | 1 + board/freescale/ls1021atwr/ls1021atwr.c | 1 + 2 files changed, 2 insertions(+), 0 deletions(-)
board/freescale/ls1021aqds/ls1021aqds.c +1 -0
@@ -244,6 +244,7 @@ void board_init_f(ulong dummy)if (major ==SOC_MAJOR_VER_1_0 )out_le32 (&cci->ctrl_ord,CCI400_CTRLORD_TERM_BARRIER ); +timer_init ();dram_init ();/* Allow OCRAM access permission as R/W */
board/freescale/ls1021atwr/ls1021atwr.c +1 -0
@@ -467,6 +467,7 @@ void board_init_f(ulong dummy)preloader_console_init (); +timer_init ();dram_init ();/* Allow OCRAM access permission as R/W */
Signature · 1 line
1.7.1
PATCH 1/1 arm: ls1021a: Add timer_init() in board_init_f for SPL
Quoted 12 lines · Alison Wang
I2C is used to access DDR SPD in the DDR initialization for SPL. In
i2c_writeprocess,get_timer()will be called. Inboard_init_ffor SPL,timer_init()is not called before. The system counter is not enabled and the counter frequency is not set to 12.5MHz in SPL. The parameters fordo_div()are zero too.It could not be found until
CONFIG_USE_PRIVATE_LIBGCCis enabled in default. WhenCONFIG_USE_PRIVATE_LIBGCCis enabled, U-Boot will use its own set of libgcc functions. As the parameters fordo_div()are zero,__div0will be called. Then the processor will stay in an endless loop after callinghang().
Quoted 5 lines
This patch will add
timer_init()inboard_init_ffor SPL and fix a series of issues it caused.Signed-off-by Alison Wang <[email protected]>---
This set is applied to fsl-qoriq master, awaiting upstream. Thanks.
York