Skip to contentSkip to conversation

arm64: allwinner: h6: Add common orangepi nodes into dtsi

PATCH New Jagan Teki 2 participants 4 messages Nov 5, 2018 – Nov 13, 2018

Subsystems (2)
lore
Share & tools
lore

Jagan Teki

author
#0 lore raw

PATCH 1/2 arm64: allwinner: h6: Add common orangepi nodes into dtsi

Based on the information from hardware schematics and orangepi vendor orangepi H6 boards, One Plus and Lite2 shares common nodes like axp805, uart, mmc0 etc. The common differences between them is
- One Plus, has Ethernet
- Lite2, has Wifi, USB3, CSI port.

So, add common orangepi nodes into sun50i-h6-orangepi.dtsi so-that it case use on respective orangepi h6 board dts files.

Cc zhaoyifan <[email protected]>
---
 arch/arm/dts/sun50i-h6-orangepi-one-plus.dts | 140 +----------------
 arch/arm/dts/sun50i-h6-orangepi.dtsi         | 150 +++++++++++++++++++
 2 files changed, 151 insertions(+), 139 deletions(-)
 create mode 100644 arch/arm/dts/sun50i-h6-orangepi.dtsi
arch/arm/dts/sun50i-h6-orangepi-one-plus.dts +1 -139
index 0612c19cd9..12e17567ab 100644
@@ -4,147 +4,9 @@
  * Author: Jagan Teki <[email protected]>
  */
 
-/dts-v1/;
-
-#include "sun50i-h6.dtsi"
-
-#include <dt-bindings/gpio/gpio.h>
+#include "sun50i-h6-orangepi.dtsi"
 
 / {
 	model = "OrangePi One Plus";
 	compatible = "xunlong,orangepi-one-plus", "allwinner,sun50i-h6";
-
-	aliases {
-		serial0 = &uart0;
-	};
-
-	chosen {
-		stdout-path = "serial0:115200n8";
-	};
-};
-
-&mmc0 {
-	pinctrl-names = "default";
-	pinctrl-0 = <&mmc0_pins>;
-	vmmc-supply = <&reg_cldo1>;
-	cd-gpios = <&pio 5 6 GPIO_ACTIVE_LOW>;
-	bus-width = <4>;
-	status = "okay";
-};
-
-&r_i2c {
-	status = "okay";
-
-	axp805: pmic at 36 {
-		compatible = "x-powers,axp805", "x-powers,axp806";
-		reg = <0x36>;
-		interrupt-parent = <&r_intc>;
-		interrupts = <0 IRQ_TYPE_LEVEL_LOW>;
-		interrupt-controller;
-		#interrupt-cells = <1>;
-		x-powers,self-working-mode;
-
-		regulators {
-			reg_aldo1: aldo1 {
-				regulator-always-on;
-				regulator-min-microvolt = <3300000>;
-				regulator-max-microvolt = <3300000>;
-				regulator-name = "vcc-pl";
-			};
-
-			reg_aldo2: aldo2 {
-				regulator-min-microvolt = <3300000>;
-				regulator-max-microvolt = <3300000>;
-				regulator-name = "vcc-ac200";
-			};
-
-			reg_aldo3: aldo3 {
-				regulator-always-on;
-				regulator-min-microvolt = <3300000>;
-				regulator-max-microvolt = <3300000>;
-				regulator-name = "vcc25-dram";
-			};
-
-			reg_bldo1: bldo1 {
-				regulator-always-on;
-				regulator-min-microvolt = <1800000>;
-				regulator-max-microvolt = <1800000>;
-				regulator-name = "vcc-bias-pll";
-			};
-
-			reg_bldo2: bldo2 {
-				regulator-always-on;
-				regulator-min-microvolt = <1800000>;
-				regulator-max-microvolt = <1800000>;
-				regulator-name = "vcc-efuse-pcie-hdmi-io";
-			};
-
-			reg_bldo3: bldo3 {
-				regulator-always-on;
-				regulator-min-microvolt = <1800000>;
-				regulator-max-microvolt = <1800000>;
-				regulator-name = "vcc-dcxoio";
-			};
-
-			bldo4 {
-				/* unused */
-			};
-
-			reg_cldo1: cldo1 {
-				regulator-always-on;
-				regulator-min-microvolt = <3300000>;
-				regulator-max-microvolt = <3300000>;
-				regulator-name = "vcc-3v3";
-			};
-
-			reg_cldo2: cldo2 {
-				regulator-min-microvolt = <3300000>;
-				regulator-max-microvolt = <3300000>;
-				regulator-name = "vcc-wifi-1";
-			};
-
-			reg_cldo3: cldo3 {
-				regulator-min-microvolt = <3300000>;
-				regulator-max-microvolt = <3300000>;
-				regulator-name = "vcc-wifi-2";
-			};
-
-			reg_dcdca: dcdca {
-				regulator-always-on;
-				regulator-min-microvolt = <810000>;
-				regulator-max-microvolt = <1080000>;
-				regulator-name = "vdd-cpu";
-			};
-
-			reg_dcdcc: dcdcc {
-				regulator-min-microvolt = <810000>;
-				regulator-max-microvolt = <1080000>;
-				regulator-name = "vdd-gpu";
-			};
-
-			reg_dcdcd: dcdcd {
-				regulator-always-on;
-				regulator-min-microvolt = <960000>;
-				regulator-max-microvolt = <960000>;
-				regulator-name = "vdd-sys";
-			};
-
-			reg_dcdce: dcdce {
-				regulator-always-on;
-				regulator-min-microvolt = <1200000>;
-				regulator-max-microvolt = <1200000>;
-				regulator-name = "vcc-dram";
-			};
-
-			sw {
-				/* unused */
-			};
-		};
-	};
-};
-
-&uart0 {
-	pinctrl-names = "default";
-	pinctrl-0 = <&uart0_ph_pins>;
-	status = "okay";
 };
arch/arm/dts/sun50i-h6-orangepi.dtsi new file +150 -0

150 lines not on this page · raw message

Signature · 1 line
2.18.0.321.gffc6fa0e3
author
#1 lore raw

PATCH 2/2 board: allwinner: sun50i-h6: Add Orangepi Lite2 support

OrangePi Lite2 is Allwinner H6 based open-source SBC, which support:
- Allwinner H6 Quad-core 64-bit ARM Cortex-A53
- GPU Mali-T720
- 1GB LPDDR3 RAM
- AXP805 PMIC
- AP6356S Wifi/BT
- USB 2.0, USB 3.0 Host, OTG
- HDMI port
- 5V/2A DC power supply

---
 arch/arm/dts/Makefile                     |  1 +
 arch/arm/dts/sun50i-h6-orangepi-lite2.dts | 11 +++++++++++
 board/sunxi/MAINTAINERS                   |  5 +++++
 configs/orangepi_lite2_defconfig          | 12 ++++++++++++
 4 files changed, 29 insertions(+)
 create mode 100644 arch/arm/dts/sun50i-h6-orangepi-lite2.dts
 create mode 100644 configs/orangepi_lite2_defconfig
arch/arm/dts/Makefile +1 -0
index 3093c1185e..f7d35da7b3 100644
@@ -396,6 +396,7 @@ dtb-$(CONFIG_MACH_SUN50I_H5) += \
 	sun50i-h5-orangepi-prime.dtb \
 	sun50i-h5-orangepi-zero-plus2.dtb
 dtb-$(CONFIG_MACH_SUN50I_H6) += \
+	sun50i-h6-orangepi-lite2.dtb \
 	sun50i-h6-orangepi-one-plus.dtb \
 	sun50i-h6-pine-h64.dtb
 dtb-$(CONFIG_MACH_SUN50I) += \
arch/arm/dts/sun50i-h6-orangepi-lite2.dts new file +11 -0
new file mode 100644
index 0000000000..e098a2475f
@@ -0,0 +1,11 @@
+// SPDX-License-Identifier: (GPL-2.0+ or MIT)
+/*
+ * Copyright (C) 2018 Jagan Teki <[email protected]>
+ */
+
+#include "sun50i-h6-orangepi.dtsi"
+
+/ {
+	model = "OrangePi Lite2";
+	compatible = "xunlong,orangepi-lite2", "allwinner,sun50i-h6";
+};
board/sunxi/MAINTAINERS +5 -0
index d34cf7db30..478e37285f 100644
@@ -335,6 +335,11 @@ S:	Maintained
 F:	configs/A20-Olimex-SOM204-EVB_defconfig
 F:	configs/A20-Olimex-SOM204-EVB-eMMC_defconfig
 
+ORANGEPI LITE2 BOARD
+M:	Jagan Teki <[email protected]>
+S:	Maintained
+F:	configs/orangepi_lite2_defconfig
+
 ORANGEPI ONE PLUS BOARD
 M:	Jagan Teki <[email protected]>
 S:	Maintained
configs/orangepi_lite2_defconfig new file +12 -0
new file mode 100644
index 0000000000..e5f7d15bf6
@@ -0,0 +1,12 @@
+CONFIG_ARM=y
+CONFIG_ARCH_SUNXI=y
+CONFIG_SPL=y
+CONFIG_MACH_SUN50I_H6=y
+CONFIG_MMC0_CD_PIN="PF6"
+# CONFIG_PSCI_RESET is not set
+CONFIG_NR_DRAM_BANKS=1
+# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
+# CONFIG_CMD_FLASH is not set
+# CONFIG_SPL_DOS_PARTITION is not set
+# CONFIG_SPL_EFI_PARTITION is not set
+CONFIG_DEFAULT_DEVICE_TREE="sun50i-h6-orangepi-lite2"
Signature · 1 line
2.18.0.321.gffc6fa0e3
#2 lore raw

PATCH 2/2 board: allwinner: sun50i-h6: Add Orangepi Lite2 support

Quoted 11 lines · Jagan Teki

OrangePi Lite2 is Allwinner H6 based open-source SBC, which support:
- Allwinner H6 Quad-core 64-bit ARM Cortex-A53
- GPU Mali-T720
- 1GB LPDDR3 RAM
- AXP805 PMIC
- AP6356S Wifi/BT
- USB 2.0, USB 3.0 Host, OTG
- HDMI port
- 5V/2A DC power supply

Quoted 1 line

For both patches,

Thanks!
Maxime

Signature · 10 lines
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 228 bytes
Desc: not available
URL: <http://lists.denx.de/pipermail/u-boot/attachments/20181105/52e8aaae/attachment.sig>
author
#3 lore raw

PATCH 2/2 board: allwinner: sun50i-h6: Add Orangepi Lite2 support

Quoted 13 lines · Maxime Ripard
Quoted 11 lines · Jagan Teki

OrangePi Lite2 is Allwinner H6 based open-source SBC, which support:
- Allwinner H6 Quad-core 64-bit ARM Cortex-A53
- GPU Mali-T720
- 1GB LPDDR3 RAM
- AXP805 PMIC
- AP6356S Wifi/BT
- USB 2.0, USB 3.0 Host, OTG
- HDMI port
- 5V/2A DC power supply

Quoted 4 lines
Quoted 1 line

For both patches,

Applied to u-boot-sunxi/master