pwm: kconfig: enable kona pwm to be built for cygnus arch
PATCH v3 1/1 pwm: kconfig: enable kona pwm to be built for cygnus arch
The Cygnus architecture use a Kona PWM. This is already present in the device tree but can't be built actually. Hence, allow the Kona PWM to be built for Cygnus arch.
Signed-off-by Clément Péron <[email protected]>
Reviewed-by Florian Fainelli <[email protected]>
Reviewed-by Scott Branden <[email protected]>
Acked-by Uwe Kleine-König <[email protected]>
--- drivers/pwm/Kconfig | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-)
drivers/pwm/Kconfig +3 -1
@@ -88,7 +88,9 @@ config PWM_BCM_IPROC config PWM_BCM_KONA tristate "Kona PWM support" - depends on ARCH_BCM_MOBILE + depends on ARCH_BCM_MOBILE || ARCH_BCM_CYGNUS || COMPILE_TEST + depends on HAVE_CLK && HAS_IOMEM + default ARCH_BCM_MOBILE || ARCH_BCM_CYGNUS help Generic PWM framework driver for Broadcom Kona PWM block.
Signature · 1 line
2.19.1
Thierry Reding
AppliedQuoted 11 lines · Clément Péron
The Cygnus architecture use a Kona PWM. This is already present in the device tree but can't be built actually. Hence, allow the Kona PWM to be built for Cygnus arch.
Signed-off-by Clément Péron <[email protected]>Reviewed-by Florian Fainelli <[email protected]>Reviewed-by Scott Branden <[email protected]>Acked-by Uwe Kleine-König <[email protected]>--- drivers/pwm/Kconfig | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-)
Applied, thanks. I did fixup the subject to be consistent with other commit messages.
Thierry