ARM: imx6qdl-sabresd: Use GPIO_ACTIVE_HIGH for regulators
Subsystems (2)
Fabio Estevam
reviewerPATCH 1/1 ARM: imx6qdl-sabresd: Use GPIO_ACTIVE_HIGH for regulators
Passing GPIO_ACTIVE_HIGH as GPIO flags for the GPIO controlled regulator improves the readability, so use it instead of the hardcoded number.
Signed-off-by Fabio Estevam <[email protected]>
--- arch/arm/boot/dts/imx6qdl-sabresd.dtsi | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)
arch/arm/boot/dts/imx6qdl-sabresd.dtsi +4 -4
@@ -22,7 +22,7 @@ regulator-name = "usb_otg_vbus"; regulator-min-microvolt = <5000000>; regulator-max-microvolt = <5000000>; - gpio = <&gpio3 22 0>; + gpio = <&gpio3 22 GPIO_ACTIVE_HIGH>; enable-active-high; vin-supply = <&swbst_reg>; };
@@ -32,7 +32,7 @@ regulator-name = "usb_h1_vbus"; regulator-min-microvolt = <5000000>; regulator-max-microvolt = <5000000>; - gpio = <&gpio1 29 0>; + gpio = <&gpio1 29 GPIO_ACTIVE_HIGH>; enable-active-high; vin-supply = <&swbst_reg>; };
@@ -40,7 +40,7 @@ reg_audio: regulator-audio { compatible = "regulator-fixed"; regulator-name = "wm8962-supply"; - gpio = <&gpio4 10 0>; + gpio = <&gpio4 10 GPIO_ACTIVE_HIGH>; enable-active-high; };
@@ -51,7 +51,7 @@ regulator-name = "MPCIE_3V3"; regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; - gpio = <&gpio3 19 0>; + gpio = <&gpio3 19 GPIO_ACTIVE_HIGH>; enable-active-high; };
Signature · 7 lines
2.7.4 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Shawn Guo
AppliedQuoted 5 lines · Fabio Estevam
Passing
GPIO_ACTIVE_HIGHas GPIO flags for the GPIO controlled regulator improves the readability, so use it instead of the hardcoded number.Signed-off-by Fabio Estevam <[email protected]>
Applied, thanks.
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel