treewide: Remove trailing whitespaces and tabs
Subsystems (9)
PATCH 1/1 treewide: Remove trailing whitespaces and tabs
Just a cleanup over barebox tree
Signed-off-by Alexander Shiyan <[email protected]>
--- arch/arm/boards/nxp-imx8mq-evk/ddr_init.c | 4 ++-- arch/arm/mach-imx/include/mach/iomux-mx8.h | 2 +- arch/arm/mach-mvebu/armada-370-xp.c | 6 +++--- common/image-fit.c | 2 +- drivers/clk/imx/clk-imx7.c | 2 +- drivers/efi/efi-device.c | 2 +- drivers/pci/pcie-designware-host.c | 2 +- fs/cramfs/cramfs.c | 2 +- scripts/kconfig/gconf.c | 2 +- scripts/socfpga_mkimage.c | 2 +- 10 files changed, 13 insertions(+), 13 deletions(-)
arch/arm/boards/nxp-imx8mq-evk/ddr_init.c +2 -2
@@ -12,7 +12,7 @@ void ddr_cfg_phy(void);void ddr_init (void ) {volatile unsigned int tmp, tmp_t; - +/** Initialize DDR clock and DDRC registers **/ reg32_write (0x3038a088 ,0x7070000 );reg32_write (0x3038a084 ,0x4030000 );
@@ -177,7 +177,7 @@ void ddr_init(void)reg32_write (DDRC_SWCTL (0 ),0x0000 );/* * ------------------- 9 ------------------- -* Set DFIMISC.dfi_init_start to 1 +* Set DFIMISC.dfi_init_start to 1 * ----------------------------------------- */ reg32_write (DDRC_DFIMISC (0 ),0x00000030 );
arch/arm/mach-imx/include/mach/iomux-mx8.h +1 -1
@@ -163,7 +163,7 @@ enum {IMX8MQ_PAD_SD1_DATA5__USDHC1_DATA5 =IOMUX_PAD (0x0324 ,0x00BC ,0 ,0x0000 ,0 ,0 ),IMX8MQ_PAD_SD1_DATA5__GPIO2_IO7 =IOMUX_PAD (0x0324 ,0x00BC ,5 ,0x0000 ,0 ,0 ), -IMX8MQ_PAD_SD1_DATA6__USDHC1_DATA6 =IOMUX_PAD (0x0328 ,0x00C0 ,0 ,0x0000 ,0 ,0 ), +IMX8MQ_PAD_SD1_DATA6__USDHC1_DATA6 =IOMUX_PAD (0x0328 ,0x00C0 ,0 ,0x0000 ,0 ,0 ),IMX8MQ_PAD_SD1_DATA6__GPIO2_IO8 =IOMUX_PAD (0x0328 ,0x00C0 ,5 ,0x0000 ,0 ,0 ), IMX8MQ_PAD_SD1_DATA7__USDHC1_DATA7 = IOMUX_PAD(0x032C, 0x00C4, 0, 0x0000, 0, 0),
arch/arm/mach-mvebu/armada-370-xp.c +3 -3
@@ -105,12 +105,12 @@ static void setup_usb_phys(void)/* Power up PLL and PHY channel */ setbits_le32 (MV_USB_PHY_PLL_REG (2 ),BIT (9 )); - +/* Assert VCOCAL_START */ setbits_le32 (MV_USB_PHY_PLL_REG (1 ),BIT (21 )); - +mdelay (1 ); - +/* * USB PHY init (change from defaults) specific for 40nm (78X30 78X60) */
common/image-fit.c +1 -1
@@ -368,7 +368,7 @@ static int fit_verify_signature(struct device_node *sig_node, const void *fit) out_sl:string_list_free (&inc_nodes);string_list_free (&exc_props); - +return ret; }
drivers/clk/imx/clk-imx7.c +1 -1
@@ -743,7 +743,7 @@ static int imx7_ccm_probe(struct device_d *dev) "enet_axi_post_div", base + 0x4700, 0); clks[IMX7D_ENET1_TIME_ROOT_CLK ] =imx_clk_gate2_shared2 ("enet1_time_root_clk" ,"enet1_time_post_div" , base +0x4700 ,0 ); - clks[IMX7D_ENET2_IPG_ROOT_CLK ] =imx_clk_gate2_shared2 ("enet2_ipg_root_clk" , + clks[IMX7D_ENET2_IPG_ROOT_CLK ] =imx_clk_gate2_shared2 ("enet2_ipg_root_clk" ,"enet_axi_post_div" , base +0x4710 ,0 ); clks[IMX7D_ENET2_TIME_ROOT_CLK ] =imx_clk_gate2_shared2 ("enet2_time_root_clk" ,"enet2_time_post_div" , base +0x4710 ,0 );
drivers/efi/efi-device.c +1 -1
@@ -551,7 +551,7 @@ static int do_efi_protocol_dump(int argc, char **argv)if (len !=36 )return -EINVAL ; - +read_xbit (s, a,32 );if (*s !='-' )return -EINVAL ;
drivers/pci/pcie-designware-host.c +1 -1
@@ -391,7 +391,7 @@ void dw_pcie_setup_rc(struct pcie_port *pp) pci->iatu_unroll_enabled =dw_pcie_iatu_unroll_enabled (pci);dev_dbg (pci->dev,"iATU unroll: %s\n" , pci->iatu_unroll_enabled ?"enabled" :"disabled" ); - +dw_pcie_prog_outbound_atu (pci,PCIE_ATU_REGION_INDEX0 ,PCIE_ATU_TYPE_MEM , pp->mem_mod_base, pp->mem_bus_addr, pp->mem_size);
fs/cramfs/cramfs.c +1 -1
@@ -335,7 +335,7 @@ static struct inode *cramfs_alloc_inode(struct super_block *sb)struct cramfs_inode_info *info; info =xzalloc (sizeof (*info)); - +return &info->i_inode; }
scripts/kconfig/gconf.c +1 -1
@@ -640,7 +640,7 @@ on_set_option_mode3_activate(GtkMenuItem *menuitem, gpointer user_data)void on_introduction1_activate (GtkMenuItem * menuitem,gpointer user_data) {GtkWidget *dialog; -const gchar *intro_text = +const gchar *intro_text ="Welcome to gkc, the GTK+ graphical configuration tool\n" "For each option, a blank box indicates the feature is disabled, a\n" "check indicates it is enabled, and a dot indicates that it is to\n"
scripts/socfpga_mkimage.c +1 -1
@@ -157,7 +157,7 @@ uint32_t crc32(uint32_t crc, void *_buf, int length)return crc; } -/* Create an ARM relative branch instuction +/* Create an ARM relative branch instuction * branch is where the instruction will be placed and dest points to where * it should branch too. */ static void branch (uint8_t *branch,uint8_t *dest)
Signature · 7 lines
2.10.2 _______________________________________________ barebox mailing list [email protected] http://lists.infradead.org/mailman/listinfo/barebox
Quoted 15 lines · Alexander Shiyan
Just a cleanup over barebox tree
Signed-off-by Alexander Shiyan <[email protected]>--- arch/arm/boards/nxp-imx8mq-evk/ddr_init.c | 4 ++-- arch/arm/mach-imx/include/mach/iomux-mx8.h | 2 +- arch/arm/mach-mvebu/armada-370-xp.c | 6 +++--- common/image-fit.c | 2 +- drivers/clk/imx/clk-imx7.c | 2 +- drivers/efi/efi-device.c | 2 +- drivers/pci/pcie-designware-host.c | 2 +- fs/cramfs/cramfs.c | 2 +- scripts/kconfig/gconf.c | 2 +- scripts/socfpga_mkimage.c | 2 +- 10 files changed, 13 insertions(+), 13 deletions(-)
Applied, thanks
Sascha
Signature · 9 lines
Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list [email protected] http://lists.infradead.org/mailman/listinfo/barebox