Skip to contentSkip to conversation

input: touchscreen: ili210x: Add DT binding document

PATCH New Marek Vasut 1 participant 1 message Jan 30, 2019 1 message not in the archive

Subsystems (2)
lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw

PATCH v4 1/10 input: touchscreen: ili210x: Add DT binding document

Add DT binding document for the Ilitek ILI210x and ILI251x touchscreen controllers.

Cc Dmitry Torokhov <[email protected]>
Cc Henrik Rydberg <[email protected]>
Cc Olivier Sobrie <[email protected]>
Cc Philipp Puschmann <[email protected]>
Cc Rob Herring <[email protected]>

To: [email protected]

---
V2: New patch
V3: Replace touch@ with touchscreen@
V4: No change

---
 .../bindings/input/ilitek,ili2xxx.txt         | 25 +++++++++++++++++++
 1 file changed, 25 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/input/ilitek,ili2xxx.txt
Documentation/devicetree/bindings/input/ilitek,ili2xxx.txt new file +25 -0
new file mode 100644
index 000000000000..b2a76301e632
@@ -0,0 +1,25 @@
+Ilitek ILI210x/ILI251x touchscreen controller
+
+Required properties:
+- compatible:
+    ilitek,ili210x for ILI210x
+    ilitek,ili251x for ILI251x
+
+- reg: The I2C address of the device
+
+- interrupts: The sink for the touchscreen's IRQ output
+    See ../interrupt-controller/interrupts.txt
+
+Optional properties for main touchpad device:
+
+- reset-gpios: GPIO specifier for the touchscreen's reset pin (active low)
+
+Example:
+
+	touchscreen@41 {
+		compatible = "ilitek,ili251x";
+		reg = <0x41>;
+		interrupt-parent = <&gpio4>;
+		interrupts = <7 IRQ_TYPE_EDGE_FALLING>;
+		reset-gpios = <&gpio5 21 GPIO_ACTIVE_LOW>;
+	};
Signature · 1 line
2.19.2