arm64: defconfig: Enable PFUZE100 regulator
PATCH 1/1 arm64: defconfig: Enable PFUZE100 regulator
This is needed to boot correctly from eMMC on the i.MX8MQ EVK board.
Signed-off-by Carlo Caione <[email protected]>
--- arch/arm64/configs/defconfig | 1 + 1 file changed, 1 insertion(+)
arch/arm64/configs/defconfig +1 -0
@@ -448,6 +448,7 @@ CONFIG_REGULATOR_GPIO=y CONFIG_REGULATOR_HI6421V530=y CONFIG_REGULATOR_HI655X=y CONFIG_REGULATOR_MAX77620=y +CONFIG_REGULATOR_PFUZE100=y CONFIG_REGULATOR_PWM=y CONFIG_REGULATOR_QCOM_RPMH=y CONFIG_REGULATOR_QCOM_SMD_RPM=y
Signature · 7 lines
2.19.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Quoted 4 lines · Carlo Caione
This is needed to boot correctly from eMMC on the i.MX8MQ EVK board.
Signed-off-by Carlo Caione <[email protected]>
Reviewed-by Fabio Estevam <[email protected]>
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Shawn Guo
AppliedQuoted 3 lines · Carlo Caione
This is needed to boot correctly from eMMC on the i.MX8MQ EVK board.
Signed-off-by Carlo Caione <[email protected]>
Applied, thanks.
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel