Skip to contentSkip to conversation

dt-bindings: input: Refer to touchscreen.txt for goodix ts

PATCH New Guido Günther 1 participant 1 message Feb 11, 2019

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 dt-bindings: input: Refer to touchscreen.txt for goodix ts

Refer to touchscreen.txt for generic touch properties. This avoids duplication and we're using the generic code to parse these in the driver. While at that add touchscreen-size-{x,y} which are respected by the driver as well.

---
 .../bindings/input/touchscreen/goodix.txt           | 13 ++++++++-----
 1 file changed, 8 insertions(+), 5 deletions(-)
Documentation/devicetree/bindings/input/touchscreen/goodix.txt +8 -5
index f7e95c52f3c7..bc7796b98a00 100644
@@ -18,11 +18,14 @@ Optional properties:
  - irq-gpios		: GPIO pin used for IRQ. The driver uses the
 			  interrupt gpio pin as output to reset the device.
  - reset-gpios		: GPIO pin used for reset
-
- - touchscreen-inverted-x  : X axis is inverted (boolean)
- - touchscreen-inverted-y  : Y axis is inverted (boolean)
- - touchscreen-swapped-x-y : X and Y axis are swapped (boolean)
-                             (swapping is done after inverting the axis)
+ - touchscreen-inverted-x
+ - touchscreen-inverted-y
+ - touchscreen-size-x
+ - touchscreen-size-y
+ - touchscreen-swapped-x-y
+
+The touchscreen-* properties are documented in
+Documentation/devicetree/bindings/input/touchscreen/touchscreen.txt
 
 Example:
 
Signature · 1 line
2.20.1