Skip to contentSkip to conversation

IIO second set of new device support, cleanups and features for the 5.1 cycle.

GIT PULL Jonathan Cameron 2 participants 2 messages Feb 12, 2019 – Feb 13, 2019 IIO

lore
Share & tools
lore

Jonathan Cameron

author maintainer
#0 lore raw

The following changes since commit c2f4dd4364b71ef4eb43925b402377aefe9c1ca0:

staging: wlan-ng: formatting change in cfg80211.c (2019-02-08 10:31:14 +0100)

are available in the Git repository at:

git://git.kernel.org/pub/scm/linux/kernel/git/jic23/iio.git tags/iio-for-5.1b

for you to fetch changes up to 103cda6a3b8d2c10d5f8cd7abad118e9db8f4776:

iio: adc: exynos-adc: Use proper number of channels for Exynos4x12 (2019-02-12 20:56:00 +0000)

----------------------------------------------------------------
Second set of new device support, features and cleanup for IIO in the 5.1 cycle.

There are a few late breaking fixes in here that weren't worth trying to rush into 5.0 as they have been with us for quite a while.

New device support
* ad7476
- add support for TI ADS786X parts that are compatible with this Analog Devices driver. Good to see some simple devices are so similar.
* Ingenic jz47xx SoC ADCs
- new driver and bindings
* Plantower PMS7003 partical sensor
- new driver and bindings including vendor prefix.
* TI DAC7612
- new driver and bindings for this dual DAC.

New features
* ad7768-1
- Sampling frequency control
* bmi160
- Data ready trigger support, including open-drain dt binding.

Cleanup / minor fixes.
* Analog Device DACs
- Fix some inconsistent licenses. These are only ones where there were two different license marked in the same file, and hence were previously unclear.
* ads124s08
- Spelling fix.
* adxl345
- Parameter alignement tidy up.
* bmi160
- SPDX
- correct a note on the types of supported interrupts which was too strict.
- use iio_pollfunc_store_time to grab an earlier timestamp.
- use if (ret) instead of if (ret < 0) to be consistent whilst simplifying some handling where ret was effectively getting written to 0 even though it was always already 0.
* exynos_adc
- Fix a null pointer dereference on unbind.
- Fix number of channels on Exynos4x12 devices to be 4 rather than 8.
* lpc32xx-adc
- Move DT bindings doc out of staging. Oops, I missed this one when moving the driver.
- SPDX.
* npcm-adc
- drop documentation of reset node as going to be done differently. It's a new driver this cycle so no need to support the previous binding going forwards.
* sps30
- Fix an issue with a loop timeout test that meant it would never identify a timeout.
- Mark deliberate switch fall throughs.

----------------------------------------------------------------
Artur Rojek (3):
dt-bindings: iio/adc: Add docs for Ingenic JZ47xx SoCs ADC.
dt-bindings: iio/adc: Add bindings for Ingenic JZ47xx SoCs ADC.
IIO: add Ingenic JZ47xx ADC driver.

Colin Ian King (1):

      iio: adc: ads124s08: fix spelling mistake "converions" -> "conversions"

Dan Carpenter (1):
iio: chemical: sps30: fix a loop timeout test

Gregory CLEMENT (2):
dt-bindings: iio: adc: move lpc32xx-adc out of staging iio:adc:lpc32xx use SPDX-License-Identifier

Jonathan Cameron (1):
iio:chemical:sps30 Supress some switch fallthrough warnings.

Krzysztof Kozlowski (2):
iio: adc: exynos-adc: Fix NULL pointer exception on unbind
iio: adc: exynos-adc: Use proper number of channels for Exynos4x12

Luciana da Costa Marques (1):
iio:accel:adxl345: Change alignment to match paranthesis

Martin Kelly (6):
iio:bmi160: add SPDX identifiers iio:bmi160: add drdy interrupt support
dt-bindings: fix incorrect bmi160 IRQ note
dt-bindings: bmi160 document open-drain property iio:bmi160: use iio_pollfunc_store_time iio:bmi160: use if (ret) instead of if (ret < 0)

Ricardo Ribalda Delgado (3):
iio: adc: ad7476: Add support for TI ADS786X ADCs iio:dac:ti-dac7612: Add driver for Texas Instruments DAC7612 iio:dac:dac7612: device tree bindings

Stefan Popa (2):
drivers: iio: dac: Fix wrong license for ADI drivers
iio: adc: ad7768-1: Add support for setting the sampling frequency

Tomasz Duszynski (3):
iio: chemical: add support for Plantower PMS7003 sensor
dt-bindings: add Plantower to the vendor prefixes
dt-bindings: iio: chemical: pms7003: add device tree support

Tomer Maimon (1):
dt-binding: iio: remove rst node from NPCM ADC document

 .../devicetree/bindings/iio/adc/ingenic,adc.txt    |  48 +++
 .../bindings/{staging => }/iio/adc/lpc32xx-adc.txt |   0
 .../bindings/iio/adc/nuvoton,npcm-adc.txt          |  11 -
 .../bindings/iio/adc/samsung,exynos-adc.txt        |   4 +-
 .../bindings/iio/chemical/plantower,pms7003.txt    |  20 ++
 .../devicetree/bindings/iio/dac/ti,dac7612.txt     |  28 ++
 .../devicetree/bindings/iio/imu/bmi160.txt         |   6 +-
 .../devicetree/bindings/vendor-prefixes.txt        |   1 +
 MAINTAINERS                                        |   7 +
 drivers/iio/accel/adxl345_core.c                   |   4 +-
 drivers/iio/adc/Kconfig                            |  20 +-
 drivers/iio/adc/Makefile                           |   1 +
 drivers/iio/adc/ad7476.c                           |  20 ++
 drivers/iio/adc/ad7768-1.c                         | 202 +++++++++++-
 drivers/iio/adc/exynos_adc.c                       |  19 +-
 drivers/iio/adc/ingenic-adc.c                      | 364 +++++++++++++++++++++
 drivers/iio/adc/lpc32xx_adc.c                      |  15 +-
 drivers/iio/adc/ti-ads124s08.c                     |   8 +-
 drivers/iio/chemical/Kconfig                       |  10 +
 drivers/iio/chemical/Makefile                      |   1 +
 drivers/iio/chemical/pms7003.c                     | 340 +++++++++++++++++++
 drivers/iio/chemical/sps30.c                       |   5 +-
 drivers/iio/dac/Kconfig                            |  10 +
 drivers/iio/dac/Makefile                           |   1 +
 drivers/iio/dac/ad5686-spi.c                       |   2 +-
 drivers/iio/dac/ad5686.c                           |   2 +-
 drivers/iio/dac/ad5686.h                           |   2 +-
 drivers/iio/dac/ad5696-i2c.c                       |   2 +-
 drivers/iio/dac/ad5758.c                           |   2 +-
 drivers/iio/dac/ti-dac7612.c                       | 184 +++++++++++
 drivers/iio/imu/bmi160/bmi160.h                    |  11 +
 drivers/iio/imu/bmi160/bmi160_core.c               | 317 ++++++++++++++++--
 drivers/iio/imu/bmi160/bmi160_i2c.c                |   5 +-
 drivers/iio/imu/bmi160/bmi160_spi.c                |   4 +-
 include/dt-bindings/iio/adc/ingenic,adc.h          |  10 +
 35 files changed, 1601 insertions(+), 85 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/iio/adc/ingenic,adc.txt
 rename Documentation/devicetree/bindings/{staging => }/iio/adc/lpc32xx-adc.txt (100%)
 create mode 100644 Documentation/devicetree/bindings/iio/chemical/plantower,pms7003.txt
 create mode 100644 Documentation/devicetree/bindings/iio/dac/ti,dac7612.txt
 create mode 100644 drivers/iio/adc/ingenic-adc.c
 create mode 100644 drivers/iio/chemical/pms7003.c
 create mode 100644 drivers/iio/dac/ti-dac7612.c
 create mode 100644 include/dt-bindings/iio/adc/ingenic,adc.h
#1 lore raw
Quoted 7 lines · Jonathan Cameron

The following changes since commit c2f4dd4364b71ef4eb43925b402377aefe9c1ca0:

staging: wlan-ng: formatting change in cfg80211.c (2019-02-08 10:31:14 +0100)

are available in the Git repository at:

git://git.kernel.org/pub/scm/linux/kernel/git/jic23/iio.git tags/iio-for-5.1b

Pulled and pushed out, thanks.

greg k-h