batctl: Add hop_penalty setting command
PATCH 1/1 batctl: Add hop_penalty setting command
OpenWrt was switched to use batctl as abstraction of the sysfs and netlink configuration interface. The only additional configuration option to finish this process is hop_penalty. It is required to defines the penalty which will be applied to an not available via batctl was hop_penalty originator message's tq-field on every hop.
Signed-off-by Sven Eckelmann <[email protected]>
--- Makefile | 1 + README.rst | 15 +++++++ hop_penalty.c | 115 ++++++++++++++++++++++++++++++++++++++++++++++++++ man/batctl.8 | 4 ++ 4 files changed, 135 insertions(+) create mode 100644 hop_penalty.c
Makefile +1 -0
@@ -63,6 +63,7 @@ $(eval $(call add_command,event,y)) $(eval $(call add_command,fragmentation,y)) $(eval $(call add_command,gateways,y)) $(eval $(call add_command,gw_mode,y)) +$(eval $(call add_command,hop_penalty,y)) $(eval $(call add_command,interface,y)) $(eval $(call add_command,isolation_mark,y)) $(eval $(call add_command,log,y))
README.rst +15 -0
@@ -530,6 +530,21 @@ Usage:: batctl aggregation|ag [0|1] +batctl hop_penalty +================== + +display or modify the hop_penalty (0-255) + +Usage:: + + batctl hop_penalty|hp [penalty] + +Example:: + + $ batctl penalty + 30 + + batctl isolation_mark =====================
hop_penalty.c new file +115 -0
115 lines not on this page · raw message
man/batctl.8 +4 -0
@@ -97,6 +97,10 @@ when parameter \fB\-t\fP is specified. Parameter \fB\-r\fP will do the same but If no parameter is given the current fragmentation mode setting is displayed. Otherwise the parameter is used to enable or disable fragmentation. .br +.IP "\fBhop_penalty\fP|\fBhp\fP [\fBpenalty\fP]" +If no parameter is given the current hop penalty setting is displayed. Otherwise the parameter is used to set the +hop penalty. The penalty is can be 0-255 (255 sets originator message's TQ to zero when forwarded by this hop). +.br .IP "\fBnetwork_coding\fP|\fBnc\fP [\fB0\fP|\fB1\fP]" If no parameter is given the current network coding mode setting is displayed. Otherwise the parameter is used to enable or disable network coding.
Signature · 1 line
2.20.1