spi: bcm2835aux: support effective_speed_hz
Subsystems (3)
PATCH RESEND 5/5 spi: bcm2835aux: support effective_speed_hz
From: Martin Sperl <[email protected]>
Setting spi_transfer->effective_speed_hz in transfer_one so that it can get used in cs_change_delay configured with delay as a muliple of SPI clock cycles.
Signed-off-by Martin Sperl <[email protected]>
--- drivers/spi/spi-bcm2835aux.c | 5 ++--- 1 file changed, 2 insertions(+), 3 deletions(-)
drivers/spi/spi-bcm2835aux.c +2 -3
@@ -325,7 +325,6 @@ static int bcm2835aux_spi_transfer_one(struct spi_master *master, {struct bcm2835aux_spi *bs =spi_master_get_devdata (master);unsigned long spi_hz, clk_hz, speed; -unsigned long spi_used_hz;/* calculate the registers to handle *
@@ -353,7 +352,7 @@ static int bcm2835aux_spi_transfer_one(struct spi_master *master,/* set the new speed */ bs->cntl[0 ] |= speed <<BCM2835_AUX_SPI_CNTL0_SPEED_SHIFT ; - spi_used_hz = clk_hz / (2 * (speed +1 )); + tfr->effective_speed_hz = clk_hz / (2 * (speed +1 ));/* set transmit buffers and length */ bs->tx_buf = tfr->tx_buf;
@@ -371,7 +370,7 @@ static int bcm2835aux_spi_transfer_one(struct spi_master *master,*/ #define HZ_PER_BYTE ((9 * 1000000) / BCM2835_AUX_SPI_POLLING_LIMIT_US)/* run in polling mode for short transfers */ -if (tfr->len < spi_used_hz /HZ_PER_BYTE ) +if (tfr->len < tfr->effective_speed_hz /HZ_PER_BYTE )return bcm2835aux_spi_transfer_one_poll (master, spi, tfr);/* run in interrupt mode for all others */
--
2.11.0
Mark Brown
maintainerQuoted 5 lines · On Sat, Feb 23, 2019 at 03:07:05PM +0000, [email protected] wrote:
From: Martin Sperl <[email protected]>
Setting
spi_transfer->effective_speed_hzintransfer_oneso that it can get used incs_change_delayconfigured with delay as a muliple of SPI clock cycles.
This needs rebasing against current code.
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel