mmc: dw_mmc: Calculate timeout from transfer length
PATCH v2 1/1 mmc: dw_mmc: Calculate timeout from transfer length
The current 4-minute data transfer timeout is misleading and broken. Instead of such a long wait, calculate the timeout duration based on the length of the data transfer. The current formula is the transfer length in bits, divided by a multiplication of bus frequency in Hz, bus width, DDR mode and converted the mSec. The value is bounded from the bottom to 1000 mSec.
---
V2: Pull the timeout calculation into separate function
--- drivers/mmc/dw_mmc.c | 24 +++++++++++++++++++++--- 1 file changed, 21 insertions(+), 3 deletions(-)
drivers/mmc/dw_mmc.c +21 -3
@@ -114,22 +114,40 @@ static int dwmci_fifo_ready(struct dwmci_host *host, u32 bit, u32 *len)return 0 ; } +static unsigned int dwmci_get_timeout (struct mmc *mmc,const unsigned int size) +{ +unsigned int timeout; + + timeout = size *8 *1000 ;/* counting in bits and msec */ + timeout *=2 ;/* wait twice as long */ + timeout /= mmc->clock; + timeout /= mmc->bus_width; + timeout /= mmc->ddr_mode ?2 :1 ; + timeout = (timeout <1000 ) ?1000 : timeout; + +return timeout; +} +static int dwmci_data_transfer (struct dwmci_host *host,struct mmc_data *data) { +struct mmc *mmc = host->mmc;int ret =0 ; -u32 timeout =240000 ; -u32 mask, size, i, len =0 ; +u32 timeout, mask, size, i, len =0 ;u32 *buf =NULL ;ulong start =get_timer (0 );u32 fifo_depth = (((host->fifoth_val &RX_WMARK_MASK ) >>RX_WMARK_SHIFT ) +1 ) *2 ; - size = data->blocksize * data->blocks /4 ; + size = data->blocksize * data->blocks;if (data->flags ==MMC_DATA_READ ) buf = (unsigned int *)data->dest;else buf = (unsigned int *)data->src; + timeout =dwmci_get_timeout (mmc, size); + + size /=4 ; +for (;;) { mask =dwmci_readl (host,DWMCI_RINTSTS );/* Error during data transfer. */
Signature · 1 line
2.20.1
PATCH v2 1/1 mmc: dw_mmc: Calculate timeout from transfer length
Quoted 8 lines · Marek Vasut
The current 4-minute data transfer timeout is misleading and broken. Instead of such a long wait, calculate the timeout duration based on the length of the data transfer. The current formula is the transfer length in bits, divided by a multiplication of bus frequency in Hz, bus width, DDR mode and converted the mSec. The value is bounded from the bottom to 1000 mSec.
Quoted 8 lines
Signed-off-by Marek Vasut <[email protected]>Cc Jaehoon Chung <[email protected]>Cc Simon Glass <[email protected]>---
V2: Pull the timeout calculation into separate function--- drivers/mmc/dw_mmc.c | 24 +++++++++++++++++++++--- 1 file changed, 21 insertions(+), 3 deletions(-)