dt-bindings: ahci-fsl-qoriq: add ls1028a chip name to the list
Subsystems (3)
PATCH 1/3 dt-bindings: ahci-fsl-qoriq: add ls1028a chip name to the list
Add ls1028a compatible to bindings documentation.
---
depends on:
- http://patchwork.ozlabs.org/patch/1045217/
.../devicetree/bindings/ata/ahci-fsl-qoriq.txt | 3 ++- 1 files changed, 2 insertions(+), 1 deletions(-)
Documentation/devicetree/bindings/ata/ahci-fsl-qoriq.txt +2 -1
@@ -3,7 +3,8 @@ Binding for Freescale QorIQ AHCI SATA Controller Required properties: - reg: Physical base address and size of the controller's register area. - compatible: Compatibility string. Must be 'fsl,<chip>-ahci', where - chip could be ls1021a, ls1043a, ls1046a, ls1088a, ls2080a, lx2160a, etc. + chip could be ls1021a, ls1028a, ls1043a, ls1046a, ls1088a, ls2080a, + lx2160a, etc. - clocks: Input clock specifier. Refer to common clock bindings. - interrupts: Interrupt specifier. Refer to interrupt binding.
Signature · 1 line
1.7.1
PATCH 2/3 arm64: dts: ls1028a: Corrected the SATA ecc address.
Ls1028a SATA ecc address with more than 32 bit, so we should corrrect the address.
--- arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi | 2 +- 1 files changed, 1 insertions(+), 1 deletions(-)
arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi +1 -1
@@ -277,7 +277,7 @@ sata: sata@3200000 { compatible = "fsl,ls1028a-ahci"; reg = <0x0 0x3200000 0x0 0x10000>, - <0x0 0x20140520 0x0 0x4>; + <0x7 0x100520 0x0 0x4>; reg-names = "ahci", "sata-ecc"; interrupts = <GIC_SPI 133 IRQ_TYPE_LEVEL_HIGH>; clocks = <&clockgen 4 1>;
Signature · 1 line
1.7.1
Shawn Guo
AppliedRe: [PATCH 2/3] arm64: dts: ls1028a: Corrected the SATA ecc address.
Quoted 4 lines · Peng Ma
Ls1028a SATA ecc address with more than 32 bit, so we should corrrect the address.
Signed-off-by Peng Ma <[email protected]>
Applied, thanks.
PATCH 3/3 ahci: qoriq: add ls1028a platforms support
In reply to Peng MaLs1028a is a new introduced soc which supports ATA3.0
---
depends on:
- http://patchwork.ozlabs.org/patch/1045218/
drivers/ata/ahci_qoriq.c | 3 +++ 1 files changed, 3 insertions(+), 0 deletions(-)
drivers/ata/ahci_qoriq.c +3 -0
@@ -53,6 +53,7 @@enum ahci_qoriq_type {AHCI_LS1021A , +AHCI_LS1028A ,AHCI_LS1043A ,AHCI_LS2080A ,AHCI_LS1046A ,
@@ -72,6 +73,7 @@ struct ahci_qoriq_priv {static const struct of_device_id ahci_qoriq_of_match[] = { { .compatible ="fsl,ls1021a-ahci" , .data = (void *)AHCI_LS1021A }, + { .compatible ="fsl,ls1028a-ahci" , .data = (void *)AHCI_LS1028A }, { .compatible ="fsl,ls1043a-ahci" , .data = (void *)AHCI_LS1043A }, { .compatible ="fsl,ls2080a-ahci" , .data = (void *)AHCI_LS2080A }, { .compatible ="fsl,ls1046a-ahci" , .data = (void *)AHCI_LS1046A },
@@ -223,6 +225,7 @@ static int ahci_qoriq_phy_init(struct ahci_host_priv *hpriv)writel (AHCI_PORT_AXICC_CFG , reg_base +PORT_AXICC );break ; +case AHCI_LS1028A :case AHCI_LS1088A :case AHCI_LX2160A :if (!(qpriv->ecc_addr || ecc_initialized))
Signature · 1 line
1.7.1
Quoted 10 lines · Peng Ma
Add ls1028a compatible to bindings documentation.
Signed-off-by Peng Ma <[email protected]>---
depends on:
- http://patchwork.ozlabs.org/patch/1045217/.../devicetree/bindings/ata/ahci-fsl-qoriq.txt | 3 ++- 1 files changed, 2 insertions(+), 1 deletions(-)
Quoted 3 lines · Peng Ma
Add ls1028a compatible to bindings documentation.
Signed-off-by Peng Ma <[email protected]>
I assume that the bindings will be picked up by Axboe. Otherwise, please let me know.
Shawn
Hi Shawn,
OK, thanks.
Best Regards,
Peng
Quoted 25 lines
-----Original Message-----
From: Shawn Guo <[email protected]>
Sent: 2019年4月11日 9:37
To: Peng Ma <[email protected]>
Cc: [email protected]; [email protected]; [email protected]; Leo Li <[email protected]>; [email protected]; [email protected]; Andy Tang <[email protected]>; [email protected]; [email protected]
Subject: [EXT] Re: [PATCH 1/3] dt-bindings: ahci-fsl-qoriq: add ls1028a chip name to the listWARNING: This email was created outside of NXP. DO NOT CLICK links or attachments unless you recognize the sender and know the content is safe.
Quoted 3 lines · Peng Ma
Add ls1028a compatible to bindings documentation.
Signed-off-by Peng Ma <[email protected]>I assume that the bindings will be picked up by Axboe. Otherwise, please let me know.
Shawn