Skip to contentSkip to conversation

ARM: dts: imx6dl-sabreauto: update opp table for auto part

PATCH Applied Anson Huang 2 participants 2 messages Apr 8, 2019 – Apr 11, 2019

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 ARM: dts: imx6dl-sabreauto: update opp table for auto part

Update i.MX6DL automotive part's opp table according to i.MX6DL automotive datasheet Rev.9, 11/2018, it adds 996MHz set-point support as below:

LDO enabled(min value):
996MHz: VDDARM: 1.275V, VDDSOC: 1.175V;
792MHz: VDDARM: 1.150V, VDDSOC: 1.150V;
396MHz: VDDARM: 1.125V, VDDSOC: 1.150V;

Adding 25mV to cover board IR drop, for LDO enabled mode of 996MHz, as the max value of LDO output can NOT exceed 1.3V, so 25mV is NOT added for VDDARM.

---
 arch/arm/boot/dts/imx6dl-sabreauto.dts | 15 +++++++++++++++
 1 file changed, 15 insertions(+)
arch/arm/boot/dts/imx6dl-sabreauto.dts +15 -0
index 660d52a..ff3283c8 100644
@@ -11,3 +11,18 @@
 	model = "Freescale i.MX6 DualLite/Solo SABRE Automotive Board";
 	compatible = "fsl,imx6dl-sabreauto", "fsl,imx6dl";
 };
+
+&cpu0 {
+	operating-points = <
+		/* kHz    uV */
+		996000  1275000
+		792000  1175000
+		396000  1150000
+	>;
+	fsl,soc-operating-points = <
+		/* ARM kHz  SOC-PU uV */
+		996000	1200000
+		792000	1175000
+		396000	1175000
+	>;
+};
Signature · 1 line
2.7.4
Applied
#1 lore raw
Quoted 9 lines · Anson Huang

Update i.MX6DL automotive part's opp table according to i.MX6DL automotive datasheet Rev.9, 11/2018, it adds 996MHz set-point support as below:

LDO enabled(min value):
996MHz: VDDARM: 1.275V, VDDSOC: 1.175V;
792MHz: VDDARM: 1.150V, VDDSOC: 1.150V;
396MHz: VDDARM: 1.125V, VDDSOC: 1.150V;

Quoted 5 lines

Adding 25mV to cover board IR drop, for LDO enabled mode of 996MHz, as the max value of LDO output can NOT exceed 1.3V, so 25mV is NOT added for VDDARM.

Applied, thanks.