Skip to contentSkip to conversation

igc: Add flow control support

PATCH New Sasha Neftin 2 participants 2 messages Apr 18, 2019 – May 3, 2019

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 igc: Add flow control support

This change adds flow control settings. This is required to enable the legacy flow control support.

---
 drivers/net/ethernet/intel/igc/igc_defines.h |  3 +++
 drivers/net/ethernet/intel/igc/igc_main.c    | 22 ++++++++++++++++++++++
 2 files changed, 25 insertions(+)
drivers/net/ethernet/intel/igc/igc_defines.h +3 -0
index 5f6bc67cb33b..fc0ccfe38a20 100644
@@ -66,6 +66,9 @@
 
 #define IGC_CONNSW_AUTOSENSE_EN	0x1
 
+/* As per the EAS the maximum supported size is 9.5KB (9728 bytes) */
+#define MAX_JUMBO_FRAME_SIZE	0x2600
+
 /* PBA constants */
 #define IGC_PBA_34K		0x0022
 
drivers/net/ethernet/intel/igc/igc_main.c +22 -0
index cb8477b84d37..810d44fb77bf 100644
@@ -72,6 +72,28 @@ void igc_reset(struct igc_adapter *adapter)
 {
 	struct pci_dev *pdev = adapter->pdev;
 	struct igc_hw *hw = &adapter->hw;
+	struct igc_fc_info *fc = &hw->fc;
+	u32 pba, hwm;
+
+	/* Repartition PBA for greater than 9k mtu if required
+	 */
+	pba = IGC_PBA_34K;
+
+	/* flow control settings
+	 * The high water mark must be low enough to fit one full frame
+	 * after transmitting the pause frame.  As such we must have enough
+	 * space to allow for us to complete our current transmit and then
+	 * receive the frame that is in progress from the link partner.
+	 * Set it to:
+	 * - the full Rx FIFO size minus one full Tx plus one full Rx frame
+	 */
+	hwm = (pba << 10) - (adapter->max_frame_size + MAX_JUMBO_FRAME_SIZE);
+
+	fc->high_water = hwm & 0xFFFFFFF0;	/* 16-byte granularity */
+	fc->low_water = fc->high_water - 16;
+	fc->pause_time = 0xFFFF;
+	fc->send_xon = 1;
+	fc->current_mode = fc->requested_mode;
 
 	hw->mac.ops.reset_hw(hw);
 
Signature · 1 line
2.11.0
#1 lore raw

PATCH 1/1 igc: Add flow control support

Quoted 9 lines

From: Intel-wired-lan [mailto:intel-wired-lan-bounces at osuosl.org] On Behalf Of Sasha Neftin
Sent: Thursday, April 18, 2019 12:11 AM
To: intel-wired-lan at lists.osuosl.org
Subject: [Intel-wired-lan] [PATCH v1 1/1] igc: Add flow control support

This change adds flow control settings. This is required to enable the legacy flow control support.

Quoted 7 lines
---
 drivers/net/ethernet/intel/igc/igc_defines.h |  3 +++
 drivers/net/ethernet/intel/igc/igc_main.c    | 22
++++++++++++++++++++++
 2 files changed, 25 insertions(+)