usb: typec: ucsi: ccg: add firmware flashing support
Subsystems (2)
Heikki Krogerus
maintainerPATCH v4 3/7 usb: typec: ucsi: ccg: add firmware flashing support
From: Ajay Gupta <[email protected]>
CCGx has two copies of the firmware in addition to the bootloader. If the device is running FW1, FW2 can be updated with the new version. Dual firmware mode allows the CCG device to stay in a PD contract and support USB PD and Type-C functionality while a firmware update is in progress.
First we read the currently flashed firmware version of both primary and secondary firmware and then compare it with version of firmware file to determine if flashing is required.
Command framework is added to support sending commands to CCGx controller. We wait for response after sending the command and then read the response from RAB_RESPONSE register.
Below commands are supported,
- ENTER_FLASHING
- RESET
- PDPORT_ENABLE
- JUMP_TO_BOOT
- FLASH_ROW_RW
- VALIDATE_FW
Command specific mutex lock is also added to sync between driver and user threads.
PD port number information is added which is required while sending PD_PORT_ENABLE command
--- .../ABI/testing/sysfs-driver-ucsi-ccg | 6 + drivers/usb/typec/ucsi/ucsi_ccg.c | 827 +++++++++++++++++- 2 files changed, 820 insertions(+), 13 deletions(-) create mode 100644 Documentation/ABI/testing/sysfs-driver-ucsi-ccg
Documentation/ABI/testing/sysfs-driver-ucsi-ccg new file +6 -0
@@ -0,0 +1,6 @@ +What: /sys/bus/i2c/drivers/ucsi_ccg/.../do_flash +Date: May 2019 +Contact: Ajay Gupta <[email protected]> +Description: + Tell the driver for Cypress CCGx Type-C controller to attempt + firmware upgrade by writing [Yy1] to the file.
drivers/usb/typec/ucsi/ucsi_ccg.c +814 -13
888 lines not on this page · raw message