ARM: dts: aspeed: Add aspeed-p2a-ctrl node
Subsystems (2)
PATCH 1/2 ARM: dts: aspeed: Add aspeed-p2a-ctrl node
Add a node for the aspeed-p2a-ctrl module. This node, when enabled will disable the PCI-to-AHB bridge and then allow control of this bridge via ioctls, and access via mmap.
--- arch/arm/boot/dts/aspeed-g4.dtsi | 4 ++++ arch/arm/boot/dts/aspeed-g5.dtsi | 5 +++++ 2 files changed, 9 insertions(+)
arch/arm/boot/dts/aspeed-g4.dtsi +4 -0
@@ -165,6 +165,10 @@ compatible = "aspeed,g4-pinctrl"; }; + p2a: p2a-control { + compatible = "aspeed,ast2400-p2a-ctrl"; + status = "disabled"; + }; }; rng: hwrng at 1e6e2078 {
arch/arm/boot/dts/aspeed-g5.dtsi +5 -0
@@ -212,6 +212,11 @@ aspeed,external-nodes = <&gfx &lhc>; }; + + p2a: p2a-control { + compatible = "aspeed,ast2500-p2a-ctrl"; + status = "disabled"; + }; }; rng: hwrng at 1e6e2078 {
Signature · 1 line
2.21.0.593.g511ec345e18-goog
Quoted 6 lines · Patrick Venture
Add a node for the aspeed-p2a-ctrl module. This node, when enabled will disable the PCI-to-AHB bridge and then allow control of this bridge via ioctls, and access via mmap.
Signed-off-by Patrick Venture <[email protected]>
Applied to the aspeed SoC tree.
Cheers,
Joel
Quoted 5 lines · Patrick Venture
Add a node for the aspeed-p2a-ctrl module. This node, when enabled will disable the PCI-to-AHB bridge and then allow control of this bridge via ioctls, and access via mmap.
Signed-off-by Patrick Venture <[email protected]>
Patrick,
Please send these to Joel and Andrew (and cc the mailing lists). No need to send patches that there are active maintainers for to arm at kernel.org directly.
(As a matter of fact, drivers/soc/aspeed should go through them too, even if I applied the first patch directly just now).
-Olof