Skip to contentSkip to conversation

net: fec: Do not use netdev messages too early

PATCH Applied Fabio Estevam 2 participants 2 messages Jun 6, 2019

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 net: fec: Do not use netdev messages too early

When a valid MAC address is not found the current messages are shown:

fec 2188000.ethernet (unnamed net_device) (uninitialized): Invalid MAC address: 00:00:00:00:00:00 fec 2188000.ethernet (unnamed net_device) (uninitialized): Using random MAC address: aa:9f:25:eb:7e:aa

Since the network device has not been registered at this point, it is better to use dev_err()/dev_info() instead, which will provide cleaner log messages like these:

fec 2188000.ethernet: Invalid MAC address: 00:00:00:00:00:00 fec 2188000.ethernet: Using random MAC address: aa:9f:25:eb:7e:aa

Tested on a imx6dl-pico-pi board.

---
 drivers/net/ethernet/freescale/fec_main.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)
drivers/net/ethernet/freescale/fec_main.c +3 -3
index 848defa33d3a..2ee72452ca76 100644
@@ -1689,10 +1689,10 @@ static void fec_get_mac(struct net_device *ndev)
 	 */
 	if (!is_valid_ether_addr(iap)) {
 		/* Report it and use a random ethernet address instead */
-		netdev_err(ndev, "Invalid MAC address: %pM\n", iap);
+		dev_err(&fep->pdev->dev, "Invalid MAC address: %pM\n", iap);
 		eth_hw_addr_random(ndev);
-		netdev_info(ndev, "Using random MAC address: %pM\n",
-			    ndev->dev_addr);
+		dev_info(&fep->pdev->dev, "Using random MAC address: %pM\n",
+			 ndev->dev_addr);
 		return;
 	}
 
Signature · 1 line
2.17.1
maintainer Applied
#1 lore raw

From: Fabio Estevam <[email protected]>
Date: Thu, 6 Jun 2019 09:40:33 -0300

Quoted 10 lines

When a valid MAC address is not found the current messages are shown:

fec 2188000.ethernet (unnamed net_device) (uninitialized): Invalid MAC address: 00:00:00:00:00:00 fec 2188000.ethernet (unnamed net_device) (uninitialized): Using random MAC address: aa:9f:25:eb:7e:aa

Since the network device has not been registered at this point, it is better to use dev_err()/dev_info() instead, which will provide cleaner log messages like these:

Quoted 6 lines

fec 2188000.ethernet: Invalid MAC address: 00:00:00:00:00:00 fec 2188000.ethernet: Using random MAC address: aa:9f:25:eb:7e:aa

Tested on a imx6dl-pico-pi board.

Applied, thanks.