Skip to contentSkip to conversation

ARM: dts: Introduce the NXP LS1021A-TSN board

PATCH Applied Vladimir Oltean 2 participants 2 messages Jun 6, 2019 – Jun 13, 2019

Subsystems (4)
lore
Share & tools
lore
#0 lore raw

PATCH v4 1/1 ARM: dts: Introduce the NXP LS1021A-TSN board

The LS1021A-TSN is a development board built by VVDN/Argonboards in partnership with NXP.

It features the LS1021A SoC and the first-generation SJA1105T Ethernet switch for prototyping implementations of a subset of IEEE 802.1 TSN standards.

It has two regular Ethernet ports and four switched, TSN-capable ports.

It also features:
- One Arduino header
- One expansion header
- Two USB 3.0 ports
- One mini PCIe slot
- One SATA interface
- Accelerometer, gyroscope, temperature sensors

---
Changes from v3:
- Not all nodes were alphabetically sorted ("d->i->e" vs "d->e->i")

Changes from v2:
- Sorted nodes alphabetically
- Renamed SAI2 codec node into audio-codec

v2 patch available at:
https://lkml.org/lkml/2019/5/29/998

Changes from v1:
- Applied Shawn's feedback
- Introduced QSPI flash node

v1 patch available at:
https://patchwork.kernel.org/patch/10930451/

 arch/arm/boot/dts/Makefile        |   1 +
 arch/arm/boot/dts/ls1021a-tsn.dts | 289 ++++++++++++++++++++++++++++++
 2 files changed, 290 insertions(+)
 create mode 100644 arch/arm/boot/dts/ls1021a-tsn.dts
arch/arm/boot/dts/Makefile +1 -0
index dab2914fa293..a4eb4ca5e148 100644
@@ -602,6 +602,7 @@ dtb-$(CONFIG_SOC_IMX7ULP) += \
 dtb-$(CONFIG_SOC_LS1021A) += \
 	ls1021a-moxa-uc-8410a.dtb \
 	ls1021a-qds.dtb \
+	ls1021a-tsn.dtb \
 	ls1021a-twr.dtb
 dtb-$(CONFIG_SOC_VF610) += \
 	vf500-colibri-eval-v3.dtb \
arch/arm/boot/dts/ls1021a-tsn.dts new file +289 -0

289 lines not on this page · raw message

Signature · 1 line
2.17.1
Applied
#1 lore raw
Quoted 17 lines · Vladimir Oltean

The LS1021A-TSN is a development board built by VVDN/Argonboards in partnership with NXP.

It features the LS1021A SoC and the first-generation SJA1105T Ethernet switch for prototyping implementations of a subset of IEEE 802.1 TSN standards.

It has two regular Ethernet ports and four switched, TSN-capable ports.

It also features:
- One Arduino header
- One expansion header
- Two USB 3.0 ports
- One mini PCIe slot
- One SATA interface
- Accelerometer, gyroscope, temperature sensors

Quoted 1 line

Applied, thanks.