arm64: dts: imx8mm: Enable SNVS power key according to board design
Subsystems (2)
PATCH 1/1 arm64: dts: imx8mm: Enable SNVS power key according to board design
From: Anson Huang <[email protected]>
The SNVS power key depends on board design, by default it should be disabled in SoC DT and ONLY be enabled on board DT if it is wired up.
Signed-off-by Anson Huang <[email protected]>
--- arch/arm64/boot/dts/freescale/imx8mm-evk.dts | 4 ++++ arch/arm64/boot/dts/freescale/imx8mm.dtsi | 1 + 2 files changed, 5 insertions(+)
arch/arm64/boot/dts/freescale/imx8mm-evk.dts +4 -0
@@ -65,6 +65,10 @@ }; }; +&snvs_pwrkey { + status = "okay"; +}; + &uart2 { /* console */ pinctrl-names = "default"; pinctrl-0 = <&pinctrl_uart2>;
arch/arm64/boot/dts/freescale/imx8mm.dtsi +1 -0
@@ -439,6 +439,7 @@ interrupts = <GIC_SPI 4 IRQ_TYPE_LEVEL_HIGH>; linux,keycode = <KEY_POWER>; wakeup-source; + status = "disabled"; }; };
Signature · 7 lines
2.7.4 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Shawn Guo
AppliedQuoted 7 lines · On Thu, Jun 13, 2019 at 10:01:04AM +0800, [email protected] wrote:
From: Anson Huang <[email protected]>
The SNVS power key depends on board design, by default it should be disabled in SoC DT and ONLY be enabled on board DT if it is wired up.
Signed-off-by Anson Huang <[email protected]>
Applied, thanks.