PM / AVS: SVS: Introduce SVS engine

new file mode 100644
index 000000000000..6a71992ef162
@@ -0,0 +1,88 @@
+* Mediatek Smart Voltage Scaling (MTK SVS)
+
+This describes the device tree binding for the MTK SVS controller (bank)
+which helps provide the optimized CPU/GPU/CCI voltages. This device also
+needs thermal data to calculate thermal slope for accurately compensate
+the voltages when temperature change.
+
+Required properties:
+- compatible:
+  - "mediatek,mt8183-svs" : For MT8183 family of SoCs
+- reg: Address range of the MTK SVS controller.
+- interrupts: IRQ for the MTK SVS controller.
+- clocks, clock-names: Clocks needed for the svs controller. required
+                       clocks are:
+		       "main_clk": Main clock needed for register access
+- nvmem-cells: Phandle to the calibration data provided by a nvmem device.
+- nvmem-cell-names: Should be "svs-calibration-data" and "calibration-data"
+
+Subnodes:
+- svs_cpu_little: SVS bank device node of little CPU
+  compatible: "mediatek,mt8183-svs-cpu-little"
+  operating-points-v2: OPP table hooked by SVS little CPU bank.
+		       SVS will optimze this OPP table voltage part.
+  vcpu-little-supply: PMIC buck of little CPU
+- svs_cpu_big: SVS bank device node of big CPU
+  compatible: "mediatek,mt8183-svs-cpu-big"
+  operating-points-v2: OPP table hooked by SVS big CPU bank.
+		       SVS will optimze this OPP table voltage part.
+  vcpu-big-supply: PMIC buck of big CPU
+- svs_cci: SVS bank device node of CCI
+  compatible: "mediatek,mt8183-svs-cci"
+  operating-points-v2: OPP table hooked by SVS CCI bank.
+		       SVS will optimze this OPP table voltage part.
+  vcci-supply: PMIC buck of CCI
+- svs_gpu: SVS bank device node of GPU
+  compatible: "mediatek,mt8183-svs-gpu"
+  operating-points-v2: OPP table hooked by SVS GPU bank.
+		       SVS will optimze this OPP table voltage part.
+  vgpu-spply: PMIC buck of GPU
+
+Example:
+
+	svs: svs@1100b000 {
+		compatible = "mediatek,mt8183-svs";
+		reg = <0 0x1100b000 0 0x1000>;
+		interrupts = <GIC_SPI 127 IRQ_TYPE_LEVEL_LOW 0>;
+		clocks = <&infracfg CLK_INFRA_THERM>;
+		clock-names = "main_clk";
+		nvmem-cells = <&svs_calibration>, <&thermal_calibration>;
+		nvmem-cell-names = "svs-calibration-data", "calibration-data";
+
+		svs_cpu_little: svs_cpu_little {
+			compatible = "mediatek,mt8183-svs-cpu-little";
+			operating-points-v2 = <&cluster0_opp>;
+		};
+
+		svs_cpu_big: svs_cpu_big {
+			compatible = "mediatek,mt8183-svs-cpu-big";
+			operating-points-v2 = <&cluster1_opp>;
+		};
+
+		svs_cci: svs_cci {
+			compatible = "mediatek,mt8183-svs-cci";
+			operating-points-v2 = <&cci_opp>;
+		};
+
+		svs_gpu: svs_gpu {
+			compatible = "mediatek,mt8183-svs-gpu";
+			power-domains = <&scpsys MT8183_POWER_DOMAIN_MFG_2D>;
+			operating-points-v2 = <&gpu_opp_table>;
+		};
+	};
+
+	&svs_cpu_little {
+		vcpu-little-supply = <&mt6358_vproc12_reg>;
+	};
+
+	&svs_cpu_big {
+		vcpu-big-supply = <&mt6358_vproc11_reg>;
+	};
+
+	&svs_cci {
+		vcci-supply = <&mt6358_vproc12_reg>;
+	};
+
+	&svs_gpu {
+		vgpu-spply = <&mt6358_vgpu_reg>;
+	};

index a67eeace6a89..da9baf5b5a03 100644
@@ -18,3 +18,13 @@ config ROCKCHIP_IODOMAIN
           Say y here to enable support io domains on Rockchip SoCs. It is
           necessary for the io domain setting of the SoC to match the
           voltage supplied by the regulators.
+
+config MTK_SVS
+	bool "MediaTek Smart Voltage Scaling(SVS)"
+	depends on POWER_AVS && MTK_EFUSE
+	help
+	  The SVS engine is a piece of hardware which is used to calculate
+	  optimized voltage values of several power domains, e.g.
+	  CPU clusters/GPU/CCI, according to chip process corner, temperatures,
+	  and other factors. Then DVFS driver could apply those optimized voltage
+	  values to reduce power consumption.

index ba4c7bc69225..b487701cc4a6 100644
@@ -1,2 +1,3 @@
 obj-$(CONFIG_POWER_AVS_OMAP)		+= smartreflex.o
 obj-$(CONFIG_ROCKCHIP_IODOMAIN)		+= rockchip-io-domain.o
+obj-$(CONFIG_MTK_SVS)			+= mtk_svs.o