arm64: dts: rockchip: improve rk3328-roc-cc rgmii performance.
Subsystems (2)
PATCH 1/1 arm64: dts: rockchip: improve rk3328-roc-cc rgmii performance.
Currently the rk3328-roc-cc ethernet is enabled using "snps,force_thresh_dma_mode". While this works, the performance leaves a lot to be desired.
A previous attempt to improve performance used "snps,txpbl = <0x4>". This also allowed networking to function, but performance varied between boards.
This patch takes that one step further.
Set txpbl and rxpbl to 0x4.
This can also be accomplished with "snps,pbl =<0x4>" which affects both. Also set "snps,aal" which forces address aligned DMA mode.
--- arch/arm64/boot/dts/rockchip/rk3328-roc-cc.dts | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-)
arch/arm64/boot/dts/rockchip/rk3328-roc-cc.dts +3 -1
@@ -141,10 +141,12 @@ phy-mode = "rgmii"; pinctrl-names = "default"; pinctrl-0 = <&rgmiim1_pins>; - snps,force_thresh_dma_mode; snps,reset-gpio = <&gpio1 RK_PC2 GPIO_ACTIVE_LOW>; snps,reset-active-low; snps,reset-delays-us = <0 10000 50000>; + snps,txpbl = <0x4>; + snps,rxpbl = <0x4>; + snps,aal; tx_delay = <0x24>; rx_delay = <0x18>; status = "okay";
Signature · 1 line
2.20.1
Heiko Stuebner
maintainerAm Mittwoch, 26. Juni 2019, 15:04:43 CEST schrieb Peter Geis:
Quoted 10 lines
Currently the rk3328-roc-cc ethernet is enabled using "snps,force_thresh_dma_mode". While this works, the performance leaves a lot to be desired.
A previous attempt to improve performance used "snps,txpbl = <0x4>". This also allowed networking to function, but performance varied between boards.This patch takes that one step further.
Set txpbl and rxpbl to0x4.
This can also be accomplished with "snps,pbl =<0x4>" which affects both. Also set "snps,aal" which forces address aligned DMA mode.
Quoted 5 lines
Fixes 4bc4d6013b7f (arm64: dts: rockchip: fix rk3328-roc-cc gmac2io stability issues)Signed-off-by Peter Geis <[email protected]>
applied for 5.3 after sorting the new properties alphabetically.
Thanks
Heiko