New USB Device

Hello,

my Raspberry Pi told me to send you the following information. I hope it helps ...

best regards

Markus

--------------------------------

[    2.081893] usb 1-1.2: new full-speed USB device number 4 using dwc_otg
[    2.219804] usb 1-1.2: New USB device found, idVendor=04d8,
idProduct=f8e8, bcdDevice=48.12
[    2.219821] usb 1-1.2: New USB device strings: Mfr=1, Product=2,
SerialNumber=3
[    2.219830] usb 1-1.2: Product: GNS 5890 ADS-B Receiver
[    2.219839] usb 1-1.2: Manufacturer: www.gns-gmbh.com
[ 1517.863755] usbcore: registered new interface driver usbserial_generic
[ 1517.863830] usbserial: USB Serial support registered for generic
[ 1517.863916] usbserial_generic 1-1.2:1.0: The "generic" usb-serial
driver is only for testing and one-off prototypes.
[ 1517.863927] usbserial_generic 1-1.2:1.0: Tell
[email protected] to add your device to a proper driver.
[ 1517.863939] usbserial_generic 1-1.2:1.0: device has no bulk endpoints
[ 1517.864009] usbserial_generic 1-1.2:1.1: The "generic" usb-serial
driver is only for testing and one-off prototypes.
[ 1517.864018] usbserial_generic 1-1.2:1.1: Tell
[email protected] to add your device to a proper driver.
[ 1517.864028] usbserial_generic 1-1.2:1.1: generic converter detected
[ 1517.865108] usb 1-1.2: generic converter now attached to ttyUSB0

This device isn't even a generic usb to serial converter, why did you tell your module configuration to bind to this specific device?

thanks,

greg k-h