mx7ulp_evk: Change APLL and its PFD0 frequencies
PATCH 3/5 mx7ulp_evk: Change APLL and its PFD0 frequencies
Quoted 11 lines
From: Ye Li <[email protected]>
To support HDMI display on EVK board, the LCDIF pix clock must be 25.2Mhz. Since the its PCC divider range is from 1-8, the max rate of LCDIF PCC source clock is 201.6Mhz. This limits the source clock must from NIC1 bus clock or NIC1 clock, other sources from APLL PFDs are higher than this max rate.
The NIC1 bus clock and NIC1 clock are from DDRCLK whose parent source is APLL PFD0, so we must change the APLL PFD0 and have impact to DDRCLK, NIC1 and NIC1 bus.
Eventually, this requests to set the APLL PFD0 frequency to 302.4Mhz (25.2 * 12), with settings:
Quoted 7 lines
PFD0 FRAC: 32 APLL MULT: 22 APLL NUM: 2 APLL DENOM: 5Signed-off-by Ye Li <[email protected]>Tested-by Fancy Fang <[email protected]>Signed-off-by Peng Fan <[email protected]>
Applied to u-boot-imx, master, thanks !
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================