Skip to contentSkip to conversation

drm/panfrost: Enable devfreq to work without regulator

PATCH Applied Steven Price 2 participants 2 messages Aug 16, 2019 – Aug 19, 2019

Subsystems (3)
lore
Share & tools
lore

Steven Price

author maintainer
#0 lore raw

PATCH 1/1 drm/panfrost: Enable devfreq to work without regulator

If there is no regulator defined for the GPU then still control the frequency using the supplied clock.

Some boards have clock control but no (direct) control of the regulator. For example the HiKey960 uses a mailbox protocol to a MCU to control frequencies and doesn't directly control the voltage. This patch allows frequency control of the GPU on this system.

---
 drivers/gpu/drm/panfrost/panfrost_devfreq.c | 7 ++-----
 1 file changed, 2 insertions(+), 5 deletions(-)
drivers/gpu/drm/panfrost/panfrost_devfreq.c +2 -5
index a7c18bceb7fd..77e1ad24de53 100644
@@ -39,7 +39,7 @@ static int panfrost_devfreq_target(struct device *dev, unsigned long *freq,
 	 * If frequency scaling from low to high, adjust voltage first.
 	 * If frequency scaling from high to low, adjust frequency first.
 	 */
-	if (old_clk_rate < target_rate) {
+	if (old_clk_rate < target_rate && pfdev->regulator) {
 		err = regulator_set_voltage(pfdev->regulator, target_volt,
 					    target_volt);
 		if (err) {
@@ -58,7 +58,7 @@ static int panfrost_devfreq_target(struct device *dev, unsigned long *freq,
 		return err;
 	}
 
-	if (old_clk_rate > target_rate) {
+	if (old_clk_rate > target_rate && pfdev->regulator) {
 		err = regulator_set_voltage(pfdev->regulator, target_volt,
 					    target_volt);
 		if (err)
@@ -136,9 +136,6 @@ int panfrost_devfreq_init(struct panfrost_device *pfdev)
 	int ret;
 	struct dev_pm_opp *opp;
 
-	if (!pfdev->regulator)
-		return 0;
-
 	ret = dev_pm_opp_of_add_table(&pfdev->pdev->dev);
 	if (ret == -ENODEV) /* Optional, continue without devfreq */
 		return 0;
Signature · 1 line
2.20.1
maintainer Applied
#1 lore raw
Quoted 9 lines · Steven Price

If there is no regulator defined for the GPU then still control the frequency using the supplied clock.

Some boards have clock control but no (direct) control of the regulator. For example the HiKey960 uses a mailbox protocol to a MCU to control frequencies and doesn't directly control the voltage. This patch allows frequency control of the GPU on this system.

Quoted 4 lines
---
 drivers/gpu/drm/panfrost/panfrost_devfreq.c | 7 ++-----
 1 file changed, 2 insertions(+), 5 deletions(-)

Applied, thanks.

Rob