ARM: dts: aspeed: fp5280g2: Add led configure
Subsystems (2)
PATCH 1/1 ARM: dts: aspeed: fp5280g2: Add led configure
From: Chicago Duan <[email protected]>
Added some led configure on fp5280g2.
Change BMC init-ok gpio to led, which needs to
blink when BMC initialization is complete.
Use TAB to align some lines
Signed-off-by Chicago Duan <[email protected]>
--- .../boot/dts/aspeed-bmc-inspur-fp5280g2.dts | 55 ++++++++++++++----- 1 file changed, 40 insertions(+), 15 deletions(-)
arch/arm/boot/dts/aspeed-bmc-inspur-fp5280g2.dts +40 -15
@@ -139,14 +139,48 @@ }; leds { - compatible = "gpio-leds"; + compatible = "gpio-leds"; - power { - label = "power"; - /* TODO: dummy gpio */ - gpios = <&gpio ASPEED_GPIO(R, 1) GPIO_ACTIVE_LOW>; - }; + power { + label = "power"; + /* TODO: dummy gpio */ + gpios = <&gpio ASPEED_GPIO(R, 1) GPIO_ACTIVE_LOW>; + }; + + init-ok { + label = "init-ok"; + gpios = <&gpio ASPEED_GPIO(B, 7) GPIO_ACTIVE_LOW>; + }; + + front-memory { + label = "front-memory"; + gpios = <&gpio ASPEED_GPIO(F, 4) GPIO_ACTIVE_LOW>; + }; + + front-syshot { + label = "front-syshot"; + gpios = <&gpio ASPEED_GPIO(I, 1) GPIO_ACTIVE_LOW>; + }; + + front-syshealth { + label = "front-syshealth"; + gpios = <&gpio ASPEED_GPIO(I, 0) GPIO_ACTIVE_LOW>; + }; + front-fan { + label = "front-fan"; + gpios = <&gpio ASPEED_GPIO(H, 4) GPIO_ACTIVE_LOW>; + }; + + front-psu { + label = "front-psu"; + gpios = <&gpio ASPEED_GPIO(B, 2) GPIO_ACTIVE_LOW>; + }; + + identify { + label = "identify"; + gpios = <&gpio ASPEED_GPIO(Z, 7) GPIO_ACTIVE_LOW>; + }; }; iio-hwmon-battery {
@@ -740,15 +774,6 @@ aspeed,external-nodes = <&gfx &lhc>; }; -&gpio { - pin_gpio_b7 { - gpio-hog; - gpios = <ASPEED_GPIO(B,7) GPIO_ACTIVE_LOW>; - output-high; - line-name = "BMC_INIT_OK"; - }; -}; - &wdt1 { aspeed,reset-type = "none"; aspeed,external-signal;
Signature · 1 line
2.17.1