remove the acheive sp error
Subsystems (7)
PATCH 1/1 remove the acheive sp error
From: marcussorealheis <[email protected]>
--- drivers/clk/rockchip/clk-cpu.c | 2 +- drivers/clk/samsung/clk-cpu.c | 2 +- drivers/net/ethernet/hisilicon/hns3/hns3_enet.c | 2 +- fs/xfs/xfs_inode.c | 2 +- 4 files changed, 4 insertions(+), 4 deletions(-)
drivers/clk/rockchip/clk-cpu.c +1 -1
@@ -19,7 +19,7 @@* clock and the corresponding rate changes of the auxillary clocks of the CPU * domain. The platform clock driver provides a clock register configuration * for each configurable rate which is then used to program the clock hardware -* registers to acheive a fast co-oridinated rate change for all the CPU domain +* registers to achieve a fast co-oridinated rate change for all the CPU domain * clocks. * * On a rate change request for the CPU clock, the rate change is propagated
drivers/clk/samsung/clk-cpu.c +1 -1
@@ -19,7 +19,7 @@* clock and the corresponding rate changes of the auxillary clocks of the CPU * domain. The platform clock driver provides a clock register configuration * for each configurable rate which is then used to program the clock hardware -* registers to acheive a fast co-oridinated rate change for all the CPU domain +* registers to achieve a fast co-oridinated rate change for all the CPU domain * clocks. * * On a rate change request for the CPU clock, the rate change is propagated
drivers/net/ethernet/hisilicon/hns3/hns3_enet.c +1 -1
@@ -185,7 +185,7 @@ void hns3_set_vector_coalesce_rl(struct hns3_enet_tqp_vector *tqp_vector,/* this defines the configuration for RL (Interrupt Rate Limiter). * Rl defines rate of interrupts i.e. number of interrupts-per-second -* GL and RL(Rate Limiter) are 2 ways to acheive interrupt coalescing +* GL and RL(Rate Limiter) are 2 ways to achieve interrupt coalescing */ if (rl_reg > 0 && !tqp_vector->tx_group.coal.gl_adapt_enable &&
fs/xfs/xfs_inode.c +1 -1
@@ -2574,7 +2574,7 @@ xfs_ifree_cluster(* only using to mark the buffer as stale in the log, and to * attach stale cached inodes on it. That means it will never be * dispatched for IO. If it is, we want to know about it, and we -* want it to fail. We can acheive this by adding a write +* want it to fail. We can achieve this by adding a write * verifier to the buffer. */ bp->b_ops = &xfs_inode_buf_ops;
Signature · 1 line
2.22.0