ARM: dts: imx6q-dhcom: Enable CAN in board DTS
Subsystems (3)
PATCH v2 1/1 ARM: dts: imx6q-dhcom: Enable CAN in board DTS
Move the CAN enablement from SoM DTSi to board DTS, as each board might need different CAN configuration. Moreover, disable CAN2 on the PDK2 as it is not available on any connector. This also fixes on-SoM SD slot operation, as it shares pins with the CAN2.
To: [email protected]
---
V2: Add board name to subject
--- arch/arm/boot/dts/imx6q-dhcom-pdk2.dts | 8 ++++++++ arch/arm/boot/dts/imx6q-dhcom-som.dtsi | 2 -- 2 files changed, 8 insertions(+), 2 deletions(-)
arch/arm/boot/dts/imx6q-dhcom-pdk2.dts +8 -0
@@ -43,6 +43,14 @@ status = "okay"; }; +&can1 { + status = "okay"; +}; + +&can2 { + status = "disabled"; +}; + &hdmi { ddc-i2c-bus = <&i2c2>; status = "okay";
arch/arm/boot/dts/imx6q-dhcom-som.dtsi +0 -2
@@ -51,13 +51,11 @@ &can1 { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_flexcan1>; - status = "okay"; }; &can2 { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_flexcan2>; - status = "okay"; }; &ecspi1 {
Signature · 7 lines
2.23.0.rc1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Shawn Guo
AppliedQuoted 5 lines · Marek Vasut
Move the CAN enablement from SoM DTSi to board DTS, as each board might need different CAN configuration. Moreover, disable CAN2 on the PDK2 as it is not available on any connector. This also fixes on-SoM SD slot operation, as it shares pins with the CAN2.
Quoted 7 lines
Signed-off-by Marek Vasut <[email protected]>Reviewed-by Fabio Estevam <[email protected]>Cc Fabio Estevam <[email protected]>Cc Ludwig Zenz <[email protected]>Cc Shawn Guo <[email protected]>Cc NXP Linux Team <[email protected]>
Applied, thanks.
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel